MAX1482CPD View Datasheet(PDF) - Maxim Integrated
Part Name
Description
Manufacturer
MAX1482CPD Datasheet PDF : 14 Pages
| |||
20µA, 1⁄8-Unit-Load, Slew-Rate-Limited
RS-485 Transceivers
10dB/div
0Hz
500kHz/div
5MHz
Figure 9. Driver Output Waveform and FFT, Transmitting
250kbps (125kHz) Signal
TTL IN
tR, tF < 6ns
100pF
Z
D
Y
R = 54Ω
100pF
B
R
A
RECEIVER
OUT
Figure 10. Receiver Propagation-Delay Test Circuit
Table 1. Transmitting
INPUTS
RE
DE
DI
X
1
1
X
1
0
X
0
X
X = Don't Care
High-Z = High Impedance
OUTPUTS
Z
Y
0
1
1
0
High-Z
High-Z
Table 2. Receiving
INPUTS
OUTPUT
RE
DE*
A-B
RO
0
0
> +0.2V
1
0
0
< -0.2V
0
0
0
Inputs open
1
1
0
X
High-Z
X = Don't Care
High-Z = High Impedance
* DE = 0 for MAX1483 and is a Don't Care for MAX1482.
__________Applications Information
The MAX1482/MAX1483 are low-power transceivers for
RS-485 and RS-422 communications. The MAX1482
and MAX1483 are specified for data rates of at least
250kbps. The MAX1482 is a full-duplex transceiver
while the MAX1483 is half duplex. When disabled, the
driver and receiver outputs are high impedance.
The 96kΩ, 1/8-unit-load receiver input impedance of the
MAX1482/MAX1483 allows up to 256 transceivers on a
bus, compared to the 1-unit load (12kΩ input imped-
ance) of standard RS-485 drivers (32 transceivers max-
imum). Any combination of MAX1482/MAX1483 and
other RS-485 transceivers with a total of 32 unit loads or
less can be put on the bus.
Reduced EMI and Reflections
The MAX1482/MAX1483 are slew-rate limited, minimiz-
ing EMI and reducing reflections caused by improperly
terminated cables. Figure 9 shows both the driver out-
put waveform of a MAX1482/MAX1483 transmitting a
125kHz signal and the Fourier analysis of that signal.
High-frequency harmonics have much lower ampli-
tudes, and the potential for EMI is significantly reduced.
8 _______________________________________________________________________________________
Share Link: 