56F803 View Datasheet(PDF) - Motorola => Freescale
Part Name
Description
Manufacturer
56F803 Datasheet PDF : 48 Pages
| |||
Freescale Semiconductor, Inc.
2.2 Power and Ground Signals
Table 3. Power Inputs
No. of Pins Signal Name
Signal Description
6
VDD
Power—These pins provide power to the internal structures of the chip, and
should all be attached to VDD.
1
VDDA
Analog Power—This pin is a dedicated power pin for the analog portion of the
chip and should be connected to a low noise 3.3V supply.
Table 4. Grounds
No. of Pins Signal Name
Signal Description
5
VSS
GND—These pins provide grounding for the internal structures of the chip, and
should all be attached to VSS.
1
VSSA
Analog Ground—This pin supplies an analog ground.
1
TCS
TCS—This Schmitt pin is reserved for factory use and must be tied to VSS for
normal use. In block diagrams, this pin is considered an additional VSS.
Table 5. Supply Capacitors
No. of
Pins
Signal
Name
Signal State During
Type
Reset
Signal Description
2
VCAPC Supply
Supply
VCAPC—Connect each pin to a 2.2 µF or greater bypass
capacitor in order to bypass the core logic voltage regulator
(required for proper chip operation). For more information, please
refer to Section 5.2.
2.3 Clock and Phase Locked Loop Signals
Table 6. PLL and Clock
No. of
Pins
Signal
Name
Signal State During
Type
Reset
Signal Description
1
EXTAL
Input
Input
External Crystal Oscillator Input—This input should be
connected to an 8MHz external crystal or ceramic resonator. For
more information, please refer to Section 3.5.
1
XTAL
Input/ Chip-driven Crystal Oscillator Output—This output should be connected to
Output
an 8MHz external crystal or ceramic resonator. For more
information, please refer to Section 3.5.
This pin can also be connected to an external clock source. For
more information, please refer to Section 3.5.3.
8
56F803 Technical Data
For More Information On This Product,
Go to: www.freescale.com
Share Link: 