56F802X View Datasheet(PDF) - Freescale Semiconductor

Part Name

Description

Manufacturer

56F802X

16-bit Digital Signal Controllers

Freescale Semiconductor 

Data/Program RAM. Program Flash memory can be independently bulk erased or erased in pages.

Program Flash page erase size is 512 Bytes (256 Words).

A full set of programmable peripherals — PWM, ADCs, QSCI, QSPI, I2C, PITs, Quad Timers, DACs,

and analog comparators — supports various applications. Each peripheral can be independently shut down

to save power. Any pin in these peripherals can also be used as General Purpose Input/Outputs (GPIOs).

1.3 Award-Winning Development Environment

Processor ExpertTM (PE) provides a Rapid Application Design (RAD) tool that combines easy-to-use

component-based software application creation with an expert knowledge system.

The CodeWarrior Integrated Development Environment is a sophisticated tool for code navigation,

compiling, and debugging. A complete set of evaluation modules (EVMs), demonstration board kit and

development system cards will support concurrent engineering. Together, PE, CodeWarrior and EVMs

create a complete, scalable tools solution for easy, fast, and efficient development.

1.4 Architecture Block Diagram

The 56F8025’s architecture is shown in Figures 1-1, 1-2, 1-3, 1-4, 1-5, 1-6, and 1-7. Figure 1-1 illustrates

how the 56800E system buses communicate with internal memories and the IPBus Bridge and the internal

connections between each unit of the 56800E core. Figure 1-2 shows the peripherals and control blocks

connected to the IPBus Bridge. Figures 1-3, 1-4, 1-5, 1-6, and 1-7 detail how the device’s I/O pins are

muxed. The figures do not show the on-board regulator and power and ground signals. Please see Part 2,

Signal/Connection Descriptions, for information about which signals are multiplexed with those of other

peripherals.

1.4.1 PWM, TMR and ADC Connections

Figure 1-3 shows the over- and under-voltage connections from the ADC to the PWM and the connections

to the PWM from the TMR and GPIO. These signals can control the PWM outputs in a similar manner to

the over- and under-voltage control signals. See the 56F802x and 56F803x Peripheral Reference

Manual for additional information.

The PWM_reload_sync output can be connected to the Timer’s Channel 3 input and the Timer’s Channels

2 and 3 outputs are connected to the ADC sync inputs. Timer Channel 3 output is connected to SYNC0

and Timer Channel 2 is connected to SYNC1. These are controlled by bits in the SIM Control Register;

see Section 6.3.1.

56F8025 Data Sheet, Rev. 3

8

Freescale Semiconductor

Preliminary

Share Link: