MC56F8035 View Datasheet(PDF) - Freescale Semiconductor
Part Name
Description
Manufacturer
MC56F8035 Datasheet PDF : 161 Pages
| |||
Version History
Rev. 0
Rev. 1
Rev. 2
Rev. 3
Rev. 4
Rev. 5
Document Revision History
Description of Change
Initial public release.
• In Table 5-3, changed the ITCN_BASE address from $00 F060 (incorrect value) to
$00 F0E0 (the correct value).
• In Table 10-4, added an entry for flash data retention with less than 100 program/erase
cycles (minimum 20 years).
• In Table 10-6, changed the device clock speed in STOP mode from 8MHz to 4MHz.
• In Table 10-12, changed the typical relaxation oscillator output frequency in Standby mode
from 400kHz to 200kHz.
• Changed input propagation delay values in Table 10-20 as follows:
Old values: 1 μs typical, 2 μs maximum
New values: 35 ns typical, 45 ns maximum
• In Table 10-19, changed the maximum ADC internal clock frequency from 8MHz to
5.33MHz.
• Replaced the case outline schematics in Figure 11-2, Figure 11-3, and Figure 11-4.
Added the following note to the description of the TMS signal in Table 2-3:
Note: Always tie the TMS pin to VDD through a 2.2K resistor.
• Changed the VBA register reset value and updated the footnote in Section 5.6.8.
• Changed the STANDBY > STOP IDD values in Table 10-6 as follows:
Typical: was 290μA, is 540μA
Maximum: was 390μA, is 650μA
• Changed the POWERDOWN IDD values in Table 10-6 as follows:
Typical: was 190μA, is 440μA
Maximum: was 250μA, is 550μA
• Changed footnote 1 in Table 10-12 (was “Output frequency after application of 8MHz trim
value, at 125°C.”, is “Output frequency after application of factory trim”).
• Deleted the text “at 125°C” from Figure 10-5.
• Changed the maximum input offset voltage in Table 10-20 (was +/- 20 mV, is ±35 mV).
• In Table 2-3, change VCAP value from 4.7μF to 2.2μF.
• Revised Section 7, Security Features.
• Fixed miscellaneous typos.
56F8035/56F8025 Data Sheet, Rev. 6
2
Freescale Semiconductor
Share Link: 