6-1394461-5 View Datasheet(PDF) - Tyco Electronics

Part Name

Description

Manufacturer

6-1394461-5

SOLARLOK Photovoltaic Interconnection System

Tyco Electronics 

3.2 Connector Latching

SOLARLOK Photovoltaic Interconnection System

Assembly and Installation Guidelines (continued)

Catalog 889753-3

Revised 9-2009

When mating the SOLARLOK connectors, ensure the following:

I Connectors labeled with a plus or minus are keyed and can only be mated to similarly marked and

keyed connectors.

CAUTION:

The “neutral” designated pin connectors incorporate no keying features and must

only be used for Serial Interconnection of Photovoltaic Modules.

The neutral product should not be used where maintaining polarity is critical.

The polarity of the “neutral” connector must labeled with Part No. 1394725-1 or Part No. 1394725-2

nearby the connector.

I The connector system is fully latched only when the latches are flush with the mating connector.

I After the connector is fully latched, the optional latch locking clip may be snapped into place.

3.3 Disconnecting

Fig. 5

(Female Connector)

C A U T I O N : This connector must not be disconnected under load.

Disconnect circuit from load before unplugging connectors.

Cable assemblies should be labeled using Tyco Electronics Label, Part No. 1394470-1.

Unmating of the connector

1

CAUTION: Do not disconnect the connector under load!

2

1

1 The locking mechanism is opened by depressing the latches.

2 Pull out the connectors. While depressing the latches,

disconnect the connector by pulling the connector halves apart.

All dimensions are in millimeters unless otherwise specified. All specifications subject to change.

Consult Tyco Electronics for latest specifications.

Fig. 6

31

Share Link: