ADF7023-J View Datasheet(PDF) - Analog Devices
Part Name
Description
Manufacturer
ADF7023-J Datasheet PDF : 100 Pages
| |||
ADF7023-J
Parameter
SPURIOUS EMISSIONS
30 MHz to 710 MHz
710 MHz to 945 MHz
945 MHz to 950 MHz
958 MHz to 960 MHz
960 MHz to 1 GHz
1 GHz to 1.215 GHz
1.215 GHz to 1.8845 GHz
1.8845 GHz to 1.9196 GHz5
1.9196 GHz to 3 GHz
3 GHz to 5 GHz
OPTIMUM PA LOAD IMPEDANCE
Single-Ended PA in Transmit Mode
fRF = 915 MHz
fRF = 954MHz
Single-Ended PA in Receive Mode
fRF = 915 MHz
fRF = 954 MHz
Differential PA in Transmit Mode
fRF = 915 MHz
fRF = 954 MHz
Min Typ
−65
−63
−66
−60.7
−64
−72
−76
−69
−66
−69
Max Unit
Test Conditions/Comments
Measured as per TELEC T-245 for T96
compliance, 950 MHz to 958 MHz band,
single-ended PA with combined output. For
spurious emissions compliance in the
1.8845 GHz to 1.9196 GHz frequency band,
a seventh-order PA harmonic filter is used.
This has an insertion loss of up to 1.5 dB.
dBm/100 kHz
dBm/1 MHz
dBm/100 kHz
dBm/100 kHz DR = 100 kbps, MI = 1, n = 2, fC = 957.3 MHz
dBm/100 kHz
dBm/1 MHz
dBm/1 MHz
dBm/1 MHz
dBm/1 MHz
dBm/1 MHz
50.8 + j10.2
Ω
38.5 + j5.9
Ω
9.4 − j124
Ω
8.8 − j118.5
Ω
20.5 + j36.4
Ω
28.1 + j17.3
Ω
PA Impedance in Rx mode
Load impedance between RFIO_1P and
RFIO_1N to ensure maximum output power
1 MER is a measure of signal to noise ratio at optimal eye sampling point.
2 Optimized PLL bandwidth settings vs. data rate defined in Table 31.
3 Measured as the maximum unmodulated power.
4 A combined single-ended PA and LNA match can reduce the maximum achievable output power by up to 1 dB.
5 This includes the second harmonic.
Rev. 0 | Page 8 of 100
Share Link: 