AS3931-ZTST View Datasheet(PDF) - austriamicrosystems AG

Part Name

Description

Manufacturer

AS3931-ZTST

3D Low Power Wakeup Receiver

austriamicrosystems AG 

AS3931

Datasheet - Configuring the Product

9.5.1 M0 (Correlator Off)

Bit M0 is used to simultaneously turn off all 3 correlators. This is done by turning off the correlator clocks. This can be used to reduce power

consumption when the Direct Data Mode is used.

Table 24. M0 Bit Mode

M0

Mode

0

Low RSSI step

1

High RSSI step

lid 9.5.2 M1 (Single/Double Wake Pattern)

Bit M1 selects the number of data patterns that are necessary for wakeup detection.

Table 25. M1 Bit Mode

a M1

v 0

ill 1

Mode

Single Data pattern

Double Data pattern

9.5.3 M2, M3 (Zero-Half-Bit Detection Mode)

t Bits M2 and M3 select the number of Zero-Half-bits that are allowed to be invalid. A high level of allowed invalid Zero-Half-bits increases the error

G tolerance related to noise or interference’s, that means that the probability for the detection of a valid WAKE pattern increases. Note that in turn

s the immunity against parasitic wakeups (WAKE detection when no data has been sent, due to noise or interference’s) is reduced.

A t Table 26. M2, M3 Bit Mode

M2

M3

WAKE Pin Function

s n 0

0

3 invalid Zero-bits allowed

e 1

0

2 invalid Zero-bits allowed

m t 0

1

1 invalid Zero-bits allowed

a n 1

1

0 invalid Zero-bits allowed

o 9.5.4 M4 (Detector Time Constant)

Bit M4 is used to switch between a large and a small τ of the detector threshold adoption filter. A large τ is recommended, because it increases

c the noise margin. A small τ can be used to improve the wake sensitivity when non-specified wake-patterns are used.

l Table 27. M4 Bit Mode

M4

Mode

a 0

small τ

ic1

large τ

9.5.5 M5

Techn Not used; must always be programmed to 0 by the user!

www.austriamicrosystems.com/AS3931

Revision 6.2

23 - 30

Share Link: