AT25DF021 View Datasheet(PDF) - Atmel Corporation
Part Name
Description
Manufacturer
AT25DF021 Datasheet PDF : 41 Pages
| |||
Figure 8-1. Byte Program
CS
SCK
SI
SO
0 1 2 3 4 5 6 7 8 9 10 11 12
29 30 31 32 33 34 35 36 37 38 39
OPCODE
ADDRESS BITS A23-A0
DATA IN
0 0 0 0 0 0 1 0AAAAAA
MSB
MSB
AAADDDDDDDD
MSB
HIGH-IMPEDANCE
Figure 8-2. Page Program
CS
SCK
SI
SO
0123456789
29 30 31 32 33 34 35 36 37 38 39
OPCODE
ADDRESS BITS A23-A0
DATA IN BYTE 1
0 0 0 0 0 0 1 0AAA
MSB
MSB
AAADDDDDDDD
MSB
HIGH-IMPEDANCE
DATA IN BYTE n
DDDDDDDD
MSB
8.2 Block Erase
A block of 4, 32, or 64 Kbytes can be erased (all bits set to the logical “1” state) in a single oper-
ation by using one of three different opcodes for the Block Erase command. An opcode of 20h is
used for a 4-Kbyte erase, an opcode of 52h is used for a 32-Kbyte erase, and an opcode of D8h
is used for a 64-Kbyte erase. Before a Block Erase command can be started, the Write Enable
command must have been previously issued to the device to set the WEL bit of the Status Reg-
ister to a logical “1” state.
To perform a Block Erase, the CS pin must first be asserted and the appropriate opcode (20h,
52h, or D8h) must be clocked into the device. After the opcode has been clocked in, the three
address bytes specifying an address within the 4-, 32-, or 64-Kbyte block to be erased must be
clocked in. Any additional data clocked into the device will be ignored. When the CS pin is deas-
serted, the device will erase the appropriate block. The erasing of the block is internally self-
timed and should take place in a time of tBLKE.
Since the Block Erase command erases a region of bytes, the lower order address bits do not
need to be decoded by the device. Therefore, for a 4-Kbyte erase, address bits A11-A0 will be
ignored by the device and their values can be either a logical “1” or “0”. For a 32-Kbyte erase,
address bits A14-A0 will be ignored, and for a 64-Kbyte erase, address bits A15-A0 will be
ignored by the device. Despite the lower order address bits not being decoded by the device, the
complete three address bytes must still be clocked into the device before the CS pin is deas-
serted, and the CS pin must be deasserted on an even byte boundary (multiples of eight bits);
otherwise, the device will abort the operation and no erase operation will be performed.
10 AT25DF021
3677D–DFLASH–04/09
Share Link: 