AT49BV001A View Datasheet(PDF) - Atmel Corporation
Part Name
Description
Manufacturer
AT49BV001A Datasheet PDF : 18 Pages
| |||
Block Diagram
When the device is deselected, the CMOS standby current is less than 50 µA. For the
AT49BV001AN(T), pin 1 for the PLCC package and pin 9 for the TSOP package are no con-
nect pins. To allow for simple in-system reprogrammability, the AT49BV001A(N)(T) does not
require high input voltages for programming. Five-volt-only commands determine the read and
programming operation of the device. Reading data out of the device is similar to reading from
an EPROM; it has standard CE, OE, and WE inputs to avoid bus contention. Reprogramming
the AT49BV001A(N)(T) is performed by erasing a block of data and then programming on a
byte by byte basis. The byte programming time is a fast 30 µs. The end of a program cycle can
be optionally detected by the DATA polling feature. Once the end of a byte program cycle has
been detected, a new access for a read or program can begin. The typical number of program
and erase cycles is in excess of 10,000 cycles.
The device is erased by executing the erase command sequence; the device internally con-
trols the erase operations. There are two 8K byte parameter block sections, two main memory
blocks, and one boot block.
The device has the capability to protect the data in the boot block; this feature is enabled by a
command sequence. The 16K-byte boot block section includes a reprogramming lock out fea-
ture to provide data integrity. The boot sector is designed to contain user secure code, and
when the feature is enabled, the boot sector is protected from being reprogrammed.
In the AT49BV001AN(T), once the boot block programming lockout feature is enabled, the
contents of the boot block are permanent and cannot be changed. In the AT49BV001A(T),
once the boot block programming lockout feature is enabled, the contents of the boot block
cannot be changed with input voltage levels of 5.5 volts or less.
VCC
GND
OE
WE
CE
RESET
ADDRESS
INPUTS
CONTROL
LOGIC
Y DECODER
X DECODER
AT49BV001A(N)
DATA INPUTS/OUTPUTS
I/O7 - I/O0
8
INPUT/OUTPUT
BUFFERS
PROGRAM
DATA LATCHES
Y-GATING
MAIN MEMORY
BLOCK 2
(64K BYTES)
MAIN MEMORY
BLOCK 1
(32K BYTES)
PARAMETER
BLOCK 2
(8K BYTES)
PARAMETER
BLOCK 1
(8K BYTES)
BOOT BLOCK
(16K BYTES)
1FFFF
10000
0FFFF
08000
07FFF
06000
05FFF
04000
03FFF
00000
AT49BV001A(N)T
DATA INPUTS/OUTPUTS
I/O7 - I/O0
8
INPUT/OUTPUT
BUFFERS
PROGRAM
DATA LATCHES
Y-GATING
BOOT BLOCK
(16K BYTES)
PARAMETER
BLOCK 1
(8K BYTES)
PARAMETER
BLOCK 2
(8K BYTES)
MAIN MEMORY
BLOCK 1
(32K BYTES)
MAIN MEMORY
BLOCK 2
(64K BYTES)
1FFFF
1C000
1BFFF
1A000
19FFF
18000
17FFF
10000
0FFFF
00000
2 AT49BV001A(N)(T)
3364C–FLASH–9/03
Share Link: 