AT89C2051X2-8PC View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

AT89C2051X2-8PC

8-bit Microcontroller with 2K Bytes Flash

Atmel Corporation 

Pin Description

VCC

GND

Port 1

Port 3

RST

XTAL1

XTAL2

AT89C2051x2

Supply voltage.

Ground.

Port 1 is an 8-bit bi-directional I/O port. Port pins P1.2 to P1.7 provide internal pull-ups.

P1.0 and P1.1 require external pull-ups. P1.0 and P1.1 also serve as the positive input

(AIN0) and the negative input (AIN1), respectively, of the on-chip precision analog com-

parator. The Port 1 output buffers can sink 20 mA and can drive LED displays directly.

When 1s are written to Port 1 pins, they can be used as inputs. When pins P1.2 to P1.7

are used as inputs and are externally pulled low, they will source current (IIL) because of

the internal pull-ups.

Port 1 also receives code data during Flash programming and verification.

Port 3 pins P3.0 to P3.5, P3.7 are seven bi-directional I/O pins with internal pull-ups.

P3.6 is hard-wired as an input to the output of the on-chip comparator and is not acces-

sible as a general purpose I/O pin. The Port 3 output buffers can sink 20 mA. When 1s

are written to Port 3 pins they are pulled high by the internal pull-ups and can be used as

inputs. As inputs, Port 3 pins that are externally being pulled low will source current (IIL)

because of the pull-ups.

Port 3 also serves the functions of various special features of the AT89C2051x2 as

listed below:

Port Pin

P3.0

P3.1

P3.2

P3.3

P3.4

P3.5

Alternate Functions

RXD (serial input port)

TXD (serial output port)

INT0 (external interrupt 0)

INT1 (external interrupt 1)

T0 (timer 0 external input)

T1 (timer 1 external input)

Port 3 also receives some control signals for Flash programming and verification.

Reset input. All I/O pins are reset to 1s as soon as RST goes high. Holding the RST pin

high for two machine cycles while the oscillator is running resets the device.

Each machine cycle takes 6 oscillator or clock cycles.

Input to the inverting oscillator amplifier and input to the internal clock operating circuit.

Output from the inverting oscillator amplifier.

3

3285B–MICRO–10/03

Share Link: