AT89C5132 View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

AT89C5132

USB Microcontroller with 64K Bytes Flash Memory

Atmel Corporation 

AT89C5132

eral clock frequency is the oscillator frequency divided by 2 while in X2 mode, it is the oscillator

frequency.

Note:

1. The X2 bit reset value depends on the X2B bit in the Hardware Security Byte (see Table 12 on

page 24). Using the AT89C5132 (Flash Version) the system can boot either in standard or X2

mode depending on the X2B value. Using AT83C51SND1C (ROM Version) the system always

boots in standard mode. X2B bit can be changed to X2 mode later by software.

Figure 6-3. Mode Switching Waveforms

X1

X1 ÷ 2

X2 Bit

Clock

STD Mode

X2 Mode(1)

STD Mode

Note:

In order to prevent any incorrect operation while operating in X2 mode, the user must be aware

that all peripherals using clock frequency as time reference (timers…) will have their time refer-

ence divided by two. For example, a free running timer generating an interrupt every 20 ms will

then generate an interrupt every 10 ms.

6.3 PLL

6.3.1

PLL Description

The AT89C5132 PLL is used to generate internal high frequency clock (the PLL Clock) synchro-

nized with an external low-frequency (the Oscillator Clock). The PLL clock provides the audio

interface, and the USB interface clocks. Figure 6-4 shows the internal structure of the PLL.

The PFLD block is the Phase Frequency Comparator and Lock Detector. This block makes the

comparison between the reference clock coming from the N divider and the reverse clock com-

ing from the R divider and generates some pulses on the Up or Down signal depending on the

edge position of the reverse clock. The PLLEN bit in PLLCON register is used to enable the

clock generation. When the PLL is locked, the bit PLOCK in PLLCON register (see Table 3) is

set.

The CHP block is the Charge Pump that generates the voltage reference for the VCO by inject-

ing or extracting charges from the external filter connected on PFILT pin (see Figure 6-5). Value

of the filter components are detailed in the Section “DC Characteristics”.

The VCO block is the Voltage Controlled Oscillator controlled by the voltage Vref produced by the

charge pump. It generates a square wave signal: the PLL clock.

13

4173E–USB–09/07

Share Link: