5962-89841153A View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

5962-89841153A

High Performance E2 PLD

Atmel Corporation 

ATF22V10C(Q)

4.7 Power-up Reset

The registers in the ATF22V10Cs are designed to reset during power-up. At a point delayed

slightly from VCC crossing VRST, all registers will be reset to the low state. The output state will

depend on the polarity of the output buffer.

This feature is critical for state machine initialization. However, due to the asynchronous nature

of reset and the uncertainty of how VCC actually rises in the system, the following conditions are

required:

1. The VCC rise must be monotonic, and starts below 0.7V,

2. After reset occurs, all input and feedback setup times must be met before driving the

clock pin high, and

3. The clock must remain stable during tPR.

Figure 4-1. Power-up Reset Timing

VRST

POWER

t PR

REGISTERED

OUTPUTS

tS

tW

CLOCK

4.8 Preload of Registered Outputs

The ATF22V10C’s registers are provided with circuitry to allow loading of each register with

either a high or a low. This feature will simplify testing since any state can be forced into the reg-

isters to control test sequencing. A JEDEC file with preload is generated when a source file with

vectors is compiled. Once downloaded, the JEDEC file preload sequence will be done automati-

cally by most of the approved programmers after the programming.

5. Electronic Signature Word

There are 64 bits of programmable memory that are always available to the user, even if the

device is secured. These bits can be used for user-specific data.

6. Security Fuse Usage

A single fuse is provided to prevent unauthorized copying of the ATF22V10C fuse patterns.

Once programmed, fuse verify and preload are inhibited. However, the 64-bit User Signature

remains accessible.

The security fuse should be programmed last, as its effect is immediate.

7

0735T–PLD–5/09

Share Link: