ATTINY13 View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

ATTINY13

8-bit Microcontroller with 1K Bytes In-System Programmable Flash

Atmel Corporation 

ATtiny13

The AVR core combines a rich instruction set with 32 general purpose working registers. All 32

registers are directly connected to the Arithmetic Logic Unit (ALU), allowing two independent

registers to be accessed in one single instruction executed in one clock cycle. The resulting

architecture is more code efficient while achieving throughputs up to ten times faster than con-

ventional CISC microcontrollers.

The ATtiny13 provides the following features: 1K byte of In-System Programmable Flash, 64

bytes EEPROM, 64 bytes SRAM, 6 general purpose I/O lines, 32 general purpose working reg-

isters, one 8-bit Timer/Counter with compare modes, Internal and External Interrupts, a 4-

channel, 10-bit ADC, a programmable Watchdog Timer with internal Oscillator, and three soft-

ware selectable power saving modes. The Idle mode stops the CPU while allowing the SRAM,

Timer/Counter, ADC, Analog Comparator, and Interrupt system to continue functioning. The

Power-down mode saves the register contents, disabling all chip functions until the next Inter-

rupt or Hardware Reset. The ADC Noise Reduction mode stops the CPU and all I/O modules

except ADC, to minimize switching noise during ADC conversions.

The device is manufactured using Atmel’s high density non-volatile memory technology. The

On-chip ISP Flash allows the Program memory to be re-programmed In-System through an SPI

serial interface, by a conventional non-volatile memory programmer or by an On-chip boot code

running on the AVR core.

The ATtiny13 AVR is supported with a full suite of program and system development tools

including: C Compilers, Macro Assemblers, Program Debugger/Simulators, and Evaluation kits.

5

2535I–AVR–05/08

Share Link: