ATTINY87-15MD View Datasheet(PDF) - Atmel Corporation
Part Name
Description
Manufacturer
ATTINY87-15MD Datasheet PDF : 10 Pages
| |||
ATtiny87/ATtiny167 Automotive
1.2 DC Characteristics (Continued)
TA = –40°C to +150°C, VCC = 4.5V to 5.5V (unless otherwise noted) (Continued)
Parameters
Test Conditions
Symbol
Min.
Typ.
Max.
Unit
Output High Voltage(4),
I/O pin except RESET
IOH = –10 mA, VCC = 5V
VOH
4.0
V
Input Leakage
Current I/O Pin
VCC = 5.5V, pin low
(absolute value)
IIL
1
µA
Input Leakage
Current I/O Pin
VCC = 5.5V, pin high
(absolute value)
IIH
1
µA
Reset Pull-up Resistor
RRST
35
65
kΩ
I/O Pin Pull-up Resistor
RPU
20
50
kΩ
16 MHz, Vcc = 5V
ICC
10
15
mA
Power Supply Current 8 MHz, Vcc = 5V
ICC
Active mode
8 MHz, Vcc = 3V
ICC
5.5
8.0
mA
2.8
4.0
mA
4 MHz, Vcc = 3V
ICC
1.8
3.0
mA
16 MHz, Vcc = 5V
ICC
3.5
6.0
mA
Power Supply Current 8 MHz, Vcc = 5V
ICC
Idle mode
8 MHz, Vcc = 3V
ICC
1.8
3.0
mA
1.0
2.0
mA
4 MHz, Vcc = 3V
ICC
0.5
1.0
mA
WDT enabled, Vcc = 5V
ICC
7
150
µA
Power Supply Current WDT disabled, Vcc = 5V
ICC
Power-down mode
WDT enabled, Vcc = 3V
ICC
0.18
150
µA
5
150
µA
WDT disabled, Vcc = 3V
ICC
0.15
100
µA
Analog Comparator
Input Leakage Current
VCC = 5V
Vin = VCC/2
IACLK
–50
+50
nA
Analog Comparator
Propagation Delay
VCC = 4.0V
tACPD
180
ns
Notes: 1. “Max” means the highest value where the pin is guaranteed to be read as low
2. “Min” means the lowest value where the pin is guaranteed to be read as high
3. Although each I/O port can sink more than the test conditions (20 mA at VCC = 5V) under steady state conditions (non-tran-
sient), the following must be observed:
1] The sum of all IOL, for all ports, should not exceed 400 mA.
2] The sum of all IOL, for ports C0 - C5, should not exceed 200 mA.
3] The sum of all IOL, for ports C6, D0 - D4, should not exceed 300 mA.
4] The sum of all IOL, for ports B0 - B7, D5 - D7, should not exceed 300 mA.
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test condition.
4. For temperature range +125°C to +150°C only. For –40°C to +125°C, refer to ATtiny167automotive datasheet.
3
7792B–AVR–05/09
Share Link: 