BA5962FVM View Datasheet(PDF) - ROHM Semiconductor
Part Name
Description
Manufacturer
BA5962FVM Datasheet PDF : 5 Pages
| |||
Optical disc ICs
BA5962FVM
4. If the bias pin (Pin 2) drops below 0.7V, the output is muted. Make sure that under normal operating conditions, this
pin is at 1.0V or above.
5. The output is muted in the event of a thermal shut down, mute-on, or a bias and VCC voltage drop. Only the driver
is muted. When muted, the internal bias voltage of the output pin becomes roughly (VCC-Vf) / 2). (Vf=0.7V)
6. Please connect a bypass capacitor (0.1µF) across the supply voltage lines close to the IC pins.
7. When a capacitance load is connected to the OP amplifier output, the amplifier phase margin decreases, which causes
the peak or oscillation. When connecting such load, insert a resistance in series between the output and the
capacitance load and take a full consideration for frequency characteristics to prevent problem during practical use.
8. Do not short-circuit between any output pin and supply pin (supply fault) or ground (ground fault), or between any
output pins (load short-circuit). When mounting the IC on the circuit board, be extremely cautions about the orientation
of the IC. If the orientation is mistaken, the IC may break down, and produce smoke in some cases.
!Electrical characteristics curve
On less than 3%
(percentage occupied by copper foil),
0.6
70mm×70mm, t=1.6mm
glass epoxy mounting.
0.4
0.2
0
0 25 50 75 100 125 150 175
AMBIENT TEMPERATURE : Ta (°C)
Fig.3 Power dissipation
!External dimensions (Units : mm)
2.9±0.1
85
14
0.475
0.145−+00..0035
0.22+−00..0054
0.65 0.08 S
0.08 M
MSOP8
5/5
Share Link: 