CAT24WC164 View Datasheet(PDF) - Catalyst Semiconductor => Onsemi
Part Name
Description
Manufacturer
CAT24WC164 Datasheet PDF : 10 Pages
| |||
CAT24WC164
FUNCTIONAL DESCRIPTION
The CAT24WC164 supports the I2C Bus data
transmission protocol. This Inter-Integrated Circuit Bus
protocol defines any device that sends data to the bus to
be a transmitter and any device receiving data to be a
receiver. Data transfer is controlled by the Master device
which generates the serial clock and all START and
STOP conditions for bus access. The CAT24WC164
operates as a Slave device. Both the Master and Slave
devices can operate as either transmitter or receiver, but
the Master device controls which mode is activated. A
maximum of 8 devices may be connected to the bus as
determined by the device address inputs A0, A1, and A2.
PIN DESCRIPTIONS
SCL: Serial Clock
The CAT24WC164 serial clock input pin is used to clock
all data transfers into or out of the device. This is an input
pin.
SDA: Serial Data/Address
The CAT24WC164 bidirectional serial data/address pin
is used to transfer data into and out of the device. The
SDA pin is an open drain output and can be wire-ORed
with other open drain or open collector outputs.
A0, A1, A2: Device Address Inputs
These inputs set device address when cascading multiple
devices. When these pins are left floating the default
values are zeros.
A maximum of eight devices can be cascaded. If only
one CAT24WC164 is addressed on the bus, all three
Figure 1. Bus Timing
tF
SCL
tSU:STA
SDA IN
SDA OUT
tHIGH
tR
tLOW
tLOW
tHD:DAT
tHD:STA
tSU:DAT
tAA
tDH
tSU:STO
tBUF
Figure 2. Write Cycle Timing
SCL
SDA
8TH BIT
BYTE n
ACK
Figure 3. Start/Stop Timing
SDA
SCL
Doc. No. 1026, Rev. I
START BIT
tWR
STOP
CONDITION
START
CONDITION
ADDRESS
STOP BIT
4
Share Link: 