80960-40, -33, -25
Table 16. D.C. Specifications
Symbol
Parameter (1)
Min
Max Units
Notes
VIL Input Low Voltage for all pins except RESET
– 0.3
+0.8
V
VIH Input High Voltage for all pins except RESET
2.0
VCC + 0.3 V
VOL Output Low Voltage
0.45
V IOL = 5 mA
VOH Output High Voltage
IOH = –1 mA
2.4
IOH = – 200 µA VCC – 0.5
V
V
VILR Input Low Voltage for RESET
– 0.3
1.5
V
VIHR Input High Voltage for RESET
3.5
VCC + 0.3 V
Input Leakage Current for each pin except:
ILI1
BTERM, ONCE, DREQ3:0, STEST,
EOP3:0/TC3:0, NMI, XINT7:0, BOFF, READY,
HOLD, CLKMODE
±15
µA 0 ≤ VIN ≤ VCC (2)
Input Leakage Current for:
ILI2 BTERM, ONCE, DREQ3:0, STEST,
EOP3:0/TC3:0, NMI, XINT7:0, BOFF
0
– 300
µA VIN = 0.45 V (3)
ILI3
Input Leakage Current for:
READY, HOLD, CLKMODE
0
500
µA VIN = 2.4 V (4, 8)
ILO Output Leakage Current
±15
µA
0.45 ≤ VOUT ≤
VCC
Supply Current (80960CF-40, 33):
ICC
ICC Max
ICCTyp
1150
1000
mA (5)
mA (6)
Supply Current (80960CF-25):
ICC
ICC Max
ICCTyp
950
mA (5)
775
mA (6)
Supply Current (80960CF-16):
ICC
ICC Max
ICCTyp
750
mA (5)
575
(6)
IONCE
ONCE-mode Supply Current
80960CF-40
80960CF-33, -25, -16
225
mA
150
Input Capacitance for: CLKIN, RESET, ONCE,
CIN READY, HOLD, DREQ3:0, BOFF, XINT7:0,
0
NMI, BTERM, CLKMODE
12
pF FC = 1 MHz
COUT Output Capacitance of each output pin
12
pF FC = 1 MHz (7)
CI/O I/O Pin Capacitance
12
pF FC = 1 MHz
NOTES:
1. 80960CF-33 and -25 under the conditions described in Section 4.2, “Operating Conditions” on page 26.
2. No pullup or pulldown.
3. These pins have internal pullup resistors.
4. These pins have internal pulldown resistors.
5. Measured at worst case frequency, VCC and temperature, with device operating and outputs loaded to the
test conditions described in Section 4.5.1, “A.C. Test Conditions” on page 35.
6. ICC Typical is not tested.
7. Output Capacitance is the capacitive load of a floating output.
8. CLKMODE pin has a pulldown resistor only when ONCE pin is deasserted.
28
Datasheet