DS1677(2000) View Datasheet(PDF) - Dallas Semiconductor -> Maxim Integrated

Part Name

Description

Manufacturer

DS1677
(Rev.:2000)

Portable System Controller

Dallas Semiconductor -> Maxim Integrated 

DS1677

Automatic backup and write protection of an external SRAM is provided through the VCCO and CE0 pins.

The backup energy source used to power the RTC is also used to retain RAM data in the absence of VCC

through the VCCO pin. The chip-enable output to SRAM, CE0 , is controlled during power transients to

prevent data corruption.

The microprocessor monitor circuitry of the DS1677 provides three basic functions. First, a precision

temperature–compensated reference and comparator circuit monitors the status of VCC. When an out–of–

tolerance condition occurs, an internal power–fail signal is generated which forces the to RST the active

state. When VCC returns to an in–tolerance condition, the RST signal is kept in the active state for

250 ms to allow the power supply and processor to stabilize. The DS1677 debounces a push–button input

and guarantees an active RST pulse width of 250 ms. The third function is a watchdog timer. The

DS1677 has an internal timer that forces the RST signal to the active state if the strobe input is not driven

low prior to watchdog time–out.

The DS1677 also provides a 3–channel 8–bit successive approximation analog–to–digital converter. The

converter has an internal 2.55 volt (typical) reference voltage generated by an on–board band–gap circuit.

The A/D converter is monotonic (no missing codes) and has an internal analog filter to reduce high

frequency noise.

OPERATION

The block diagram in Figure 1 shows the main elements of the DS1677. The following paragraphs

describe the function of each pin.

DS1677 BLOCK DIAGRAM Figure 1

2 of 17

Share Link: