DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

DSP56374 View Datasheet(PDF) - Motorola => Freescale

Part Name
Description
Manufacturer
DSP56374
Motorola
Motorola => Freescale Motorola
DSP56374 Datasheet PDF : 128 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
Signal Groupings
Signal
Name
SDO5_1
SDI0_1
PE6
Table 11. Enhanced Serial Audio Interface_1 Signals (Continued)
Signal Type
State during Signal Description
Reset
Output
Input
Input, output, or
disconnected
GPIO
disconnected
Serial Data Output 5_1—When programmed as a
transmitter, SDO5_1 is used to transmit data from the TX5
serial transmit shift register.
Serial Data Input 0_1—When programmed as a receiver,
SDI0_1 is used to receive serial data into the RX0 serial
receive shift register.
Port E6—When the ESAI_1 is configured as GPIO, this
signal is individually programmable as input, output, or
internally disconnected.
The default state after reset is GPIO disconnected.
SDO4_1
SDI1_1
PE7
Output
Input
Input, output, or
disconnected
Internal Pull down resistor.
This input is 5 V tolerant
GPIO
disconnected
Serial Data Output 4_1—When programmed as a
transmitter, SDO4_1 is used to transmit data from the TX4
serial transmit shift register.
Serial Data Input 1_1—When programmed as a receiver,
SDI1_1 is used to receive serial data into the RX1 serial
receive shift register.
Port E7—When the ESAI_1 is configured as GPIO, this
signal is individually programmable as input, output, or
internally disconnected.
The default state after reset is GPIO disconnected.
SDO3_1
SDI2_1
PE8
Output
Input
Input, output, or
disconnected
Internal Pull down resistor.
This input is 5 V tolerant.
GPIO
disconnected
Serial Data Output 3—When programmed as a
transmitter, SDO3_1 is used to transmit data from the TX3
serial transmit shift register.
Serial Data Input 2—When programmed as a receiver,
SDI2_1 is used to receive serial data into the RX2 serial
receive shift register.
Port E8—When the ESAI is configured as GPIO, this signal
is individually programmable as input, output, or internally
disconnected.
The default state after reset is GPIO disconnected.
Internal Pull down resistor.
This input is 5 V tolerant.
18
PRELIMINARY
Freescale Semiconductor

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]