DSP56156 View Datasheet(PDF) - Motorola => Freescale

Part Name

Description

Manufacturer

DSP56156

16-bit Digital Signal Processor

Motorola => Freescale 

Freescale Semiconductor, Inc.

Pin Descriptions

Address and Data Bus

Bus Control

Pin Descriptions

Address and Data Bus

A0-A15

(Address Bus) — three-state, active

high outputs. A0-A15 change in t0 and

specify the address for external pro-

gram and data memory accesses. If

there is no external bus activity, A0-A15

remain at their previous values. A0-A15

are three-stated during hardware reset.

D0-D15

(Data Bus) — three-state, active

high, bidirectional input/outputs.

Read data is sampled on the trailing

edge of t2, while write data output is

enabled by the leading edge of t2 and

three-stated at the leading edge of t0. If

there is no external bus activity, D0-D15

are three-stated. D0-D15 are also three-

stated during hardware reset.

Bus Control

PS/DS (Program/Data Memory Select) —

three-state, active low output. This out-

put is asserted only when external data

memory is referenced. PS/DS timing is

the same for the A0-A15 address lines.

PS/DS is high for program memory ac-

cess and is low for data memory access. If

the external bus is not used during an in-

struction cycle (t0, t1, t2, t3), PS/DS goes

high in t0. PS/DS is in the high imped-

ance state during hardware reset.

R/W (Read/Write) — three-state, active

low output. Timing is the same as the

address lines, providing an “early

write” signal. R/W (which changes in

t0) is high for a read access and is low

for a write access. If the external bus is

not used during an instruction cycle

(t0, t1, t2, t3), R/W goes high in t0. R/W

is three-stated during hardware reset.

WR (Write Enable) — three-state, active

low output. This output is asserted dur-

ing external memory write cycles. When

WR is asserted in t1, the data bus pins

D0-D15 become outputs and the DSP

puts data on the bus during the leading

edge of t2. When WR is deasserted in t3,

the external data has been latched inside

the external device. When WR is assert-

ed, it qualifies the A0-A15 and PS/DS

pins. WR can be connected directly to

the WE pin of a static RAM. WR is three-

stated during hardware reset or when

the DSP is not bus master.

RD (Read Enable) — three-state, active

low output. This output is asserted

during external memory read cycles.

When RD is asserted in late t0/early t1,

the data bus pins D0-D15 become in-

puts and an external device is enabled

onto the data bus. When RD is deas-

serted in t3, the external data is latched

inside the DSP. When RD is asserted, it

qualifies the A0-A15 and PS/DS pins.

RD can be connected directly to the

OE pin of a static RAM or ROM. RD is

three-stated during hardware reset or

when the DSP is not bus master.

BS (Bus Strobe) — three-state, active

low output. Asserted at the start of a

bus cycle (during t0) and deasserted at

the end of the bus cycle (during t2).

This pin provides an “early bus start”

signal which can be used as address

latch and as an “early bus end” signal

which can be used by an external bus

controller. BS is three-stated during

hardware reset.

MOTOROLA

DSP56156 Data Sheet

7

For More Information On This Product,

Go to: www.freescale.com

Share Link: