DSP56303UM View Datasheet(PDF) - Freescale Semiconductor
Part Name
Description
Manufacturer
DSP56303UM Datasheet PDF : 108 Pages
| |||
Signals/Connections
Table 1-12. Enhanced Synchronous Serial Interface 0 (Continued)
Signal Name
Type
STD0
Output
State During
Reset1,2
Ignored Input
Signal Description
Serial Transmit Data—Transmits data from the Serial Transmit Shift Register.
STD0 is an output when data is transmitted.
PC5
Input or Output
Port C 5—The default configuration following reset is GPIO input PC5. When
configured as PC5, signal direction is controlled through the Port C Direction
Register. The signal can be configured as an ESSI signal STD0 through the Port
C Control Register.
Notes: 1. In the Stop state, the signal maintains the last state as follows:
• If the last state is input, the signal is an ignored input.
• If the last state is output, the signal is tri-stated.
2. The Wait processing state does not affect the signal state.
3. All inputs are 5 V tolerant.
1.9 Enhanced Synchronous Serial Interface 1 (ESSI1)
Table 1-13. Enhanced Serial Synchronous Interface 1
Signal Name
Type
SC10
Input or Output
PD0
Input or Output
SC11
PD1
Input/Output
Input or Output
SC12
Input/Output
PD2
Input or Output
State During
Reset1,2
Signal Description
Ignored Input
Serial Control 0—For asynchronous mode, this signal is used for the receive
clock I/O (Schmitt-trigger input). For synchronous mode, this signal is used
either for transmitter 1 output or for serial I/O flag 0.
Ignored Input
Port D 0—The default configuration following reset is GPIO input PD0. When
configured as PD0, signal direction is controlled through the Port D Direction
Register. The signal can be configured as an ESSI signal SC10 through the Port
D Control Register.
Serial Control 1—For asynchronous mode, this signal is the receiver frame
sync I/O. For synchronous mode, this signal is used either for Transmitter 2
output or for Serial I/O Flag 1.
Ignored Input
Port D 1—The default configuration following reset is GPIO input PD1. When
configured as PD1, signal direction is controlled through the Port D Direction
Register. The signal can be configured as an ESSI signal SC11 through the Port
D Control Register.
Serial Control Signal 2—The frame sync for both the transmitter and receiver
in synchronous mode and for the transmitter only in asynchronous mode. When
configured as an output, this signal is the internally generated frame sync signal.
When configured as an input, this signal receives an external frame sync signal
for the transmitter (and the receiver in synchronous operation).
Port D 2—The default configuration following reset is GPIO input PD2. When
configured as PD2, signal direction is controlled through the Port D Direction
Register. The signal can be configured as an ESSI signal SC12 through the Port
D Control Register.
1-12
DSP56303 Technical Data, Rev. 11
Freescale Semiconductor
Share Link: 