DSP56366 View Datasheet(PDF) - Freescale Semiconductor

Part Name

Description

Manufacturer

DSP56366

24-Bit Audio Digital Signal Processor

Freescale Semiconductor 

Signal Name

TA

BR

Type

Input

Output

Table 2-7 External Bus Control Signals (continued)

State during

Reset

Signal Description

Ignored Input Transfer Acknowledge—If the DSP is the bus master and there is no external

bus activity, or the DSP is not the bus master, the TA input is ignored. The TA

input is a data transfer acknowledge (DTACK) function that can extend an

external bus cycle indefinitely. Any number of wait states (1, 2. . .infinity) may be

added to the wait states inserted by the BCR by keeping TA deasserted. In

typical operation, TA is deasserted at the start of a bus cycle, is asserted to

enable completion of the bus cycle, and is deasserted before the next bus cycle.

The current bus cycle completes one clock period after TA is asserted

synchronous to the internal system clock. The number of wait states is

determined by the TA input or by the bus control register (BCR), whichever is

longer. The BCR can be used to set the minimum number of wait states in

external bus cycles.

In order to use the TA functionality, the BCR must be programmed to at least

one wait state. A zero wait state access cannot be extended by TA deassertion,

otherwise improper operation may result. TA can operate synchronously or

asynchronously, depending on the setting of the TAS bit in the operating mode

register (OMR).

TA functionality may not be used while performing DRAM type accesses,

otherwise improper operation may result.

Output

(deasserted)

Bus Request—BR is an active-low output, never tri-stated. BR is asserted

when the DSP requests bus mastership. BR is deasserted when the DSP no

longer needs the bus. BR may be asserted or deasserted independent of

whether the DSP56366 is a bus master or a bus slave. Bus “parking” allows BR

to be deasserted even though the DSP56366 is the bus master. (See the

description of bus “parking” in the BB signal description.) The bus request hold

(BRH) bit in the BCR allows BR to be asserted under software control even

though the DSP does not need the bus. BR is typically sent to an external bus

arbitrator that controls the priority, parking, and tenure of each master on the

same external bus. BR is only affected by DSP requests for the external bus,

never for the internal bus. During hardware reset, BR is deasserted and the

arbitration is reset to the bus slave state.

DSP56366 Technical Data, Rev. 3.1

2-6

Freescale Semiconductor

Share Link: