E910.01 View Datasheet(PDF) - ELMOS Semiconductor AG
Part Name
Description
Manufacturer
E910.01 Datasheet PDF : 17 Pages
| |||
Low side driver (8 channel, serial interface)
PRODUCTION DATA - MaY 3, 2011
E910.01
3.1.3 AC Parameters
No. Pin Parameter
Symbol Condition Min. Typ. Max. Unit
SCLK
SI
1 RESET Input capacitance
CE
TEST
2
SO
Output marginal
delay
3)
-
-
5
pF
3)
-
-
0.5
ns/pF
3 RESET RESET Pulse Width
tRESon
RESET --> L
0.31
0.62
0.93
ms
4
OUTx
Rate of Change of
Output Voltage
dVOUT/dt
RL = 1kΩ 3)
-
10
-
V/µs
5
Output Capacitance
COUT
OUT = HIGH,
VOUT = 5V 3)
-
40
60
pF
6
OUT = HIGH,
VOUT = 15V 3)
-
30
45
pF
7
Duration of Output
Short Circuit Limit
TSCL
IOUT > ISCL 1)
18.5
37
55.5
ms
8
Propagation Delay
Time CE --> OUTx
tN
see Fig. 9
RL = 1kΩ 3)
-
10
20
µs
9 SCLK Clock frequency
fSCLK
3)
-
-
2
MHz
1) When the output current exceeds the value of ISCL an internal timer is initiated and the current limit is activated. If the
current limit is still active after the time TSCL the individual output is disabled by resetting the input latch.
3) Not tested in production.
3.1.3.1 Interface Timing
Symbol Parameter
Time between falling edge (10%) or rising edge (90%) of
TLSO
the CE signal and active (90%) or high impedance state of
the SO output. Load capacitance at SO < 20pF.
TLCF
Time between falling edge (10%) of the CE signal and the
first rising edge (10%) of the SCLK clock.
Time between rising edge (10%) of the SCLK clock and the
TCSO
new data at SO output (10% or 90%). Load capacitance at SO
< 20pF.
TDS
Time between stable data at SI (90% or 10%) and falling
edge at SCLK (90%) to clock the data in: Data setup time.
TDH
Time between falling edge at SCLK (90%) and changing
of the data at SI (10% or 90%): data hold time
TLL
Time between two load cycles: CE at high level (90%)
TLCR
Time between falling edge of SCLK (90%) and rising edge of
CE (90%) signal.
3) Not tested in production.
Min. 3)
20
150
10
40
20
150
20
Max. 3)
100
60
Unit
ns
ns
ns
ns
ns
ns
ns
ELMOS Semiconductor AG reserves the right to change the detail specifications as may be required to permit improvements in the design of its products.
ELMOS Semiconductor AG
Data Sheet
QM-No.: 25DS0038E.00
6/17
Share Link: 