FDC37M609 View Datasheet(PDF) - SMSC -> Microchip

Part Name

Description

Manufacturer

FDC37M609

Enhanced Super I/O Controller with Infrared Support

SMSC -> Microchip 

MAIN STATUS REGISTER

Address 3F4 READ ONLY

The Main Status Register is a read-only register

and indicates the status of the disk controller.

The Main Status Register can be read at any

7

6

5

4

RQM

DIO

NON CMD

DMA BUSY

time. The MSR indicates when the disk

controller is ready to receive data via the Data

Register. It should be read before each byte

transferring to or from the data register except in

DMA mode. No delay is required when reading

the MSR after a data transfer.

3

DRV3

BUSY

2

DRV2

BUSY

1

DRV1

BUSY

0

DRV0

BUSY

BIT 0 - 3 DRV x BUSY

These bits are set to 1s when a drive is in the

seek portion of a command, including implied

and overlapped seeks and recalibrates.

BIT 4 COMMAND BUSY

This bit is set to a “1” when a command is in

progress. This bit will go active after the

command byte has been accepted and goes

inactive at the end of the results phase. If there

is no result phase (Seek, Recalibrate

commands), this bit is returned to a “0” after the

last command byte.

BIT 5 NON-DMA

This mode is selected in the SPECIFY

command and will be set to a “1” during the

execution phase of a command. This is for

polled data transfers and helps differentiate

between the data transfer phase and the reading

of result bytes.

BIT 6 DIO

Indicates the direction of a data transfer once a

RQM is set. A “1” indicates a read and a “0”

indicates a write is required.

BIT 7 RQM

Indicates that the host can transfer data if set to

a “1”. No access is permitted if set to a “0”.

24

Share Link: