ICS661(RevF) View Datasheet(PDF) - Integrated Device Technology

Part Name

Description

Manufacturer

ICS661
(Rev.:RevF)

PRECISION AUDIO CLOCK SOURCE

Integrated Device Technology 

ICS661

PRECISION AUDIO CLOCK SOURCE

CLOCK SYNTHESIZER

Application Information

Series Termination Resistor

Clock output traces should use series termination. To series

terminate a 50Ω trace (a commonly used trace impedance),

place a 33Ω resistor in series with the clock line, as close to

the clock output pin as possible. The nominal impedance of

the clock output is 20Ω.

Decoupling Capacitors

As with any high performance mixed-signal IC, the ICS661

must be isolated from system power supply noise to perform

optimally.

Decoupling capacitors of 0.01µF must be connected

between each VDD and the PCB ground plane. To further

guard against interfering system supply noise, the ICS661

should use one common connection to the PCB power

plane as shown in the diagram on the next page. The ferrite

bead and bulk capacitor help reduce lower frequency noise

in the supply that can lead to output clock phase modulation.

Recommended Power Supply Connection for

Optimal Device Performance

Connection to 3.3V

Power Plane

Ferrite

Bead

VDD Pin

VDD Pin

Bulk Decoupling Capacitor

(such as 1 F Tantalum)

VDD Pin

0.01 F Decoupling Capacitors

capacitance of the board to match the nominally required

crystal load capacitance. To reduce possible noise pickup,

use very short PCB traces (and no vias) been the crystal

and device.

The value of the load capacitors can be roughly determined

by the formula C = 2(CL - 6) where C is the load capacitor

connected to X1 and X2, and CL is the specified value of the

load capacitance for the crystal. A typical crystal CL is 18 pF,

so C = 2(18 - 6) = 24 pF. Because these capacitors adjust

the stray capacitance of the PCB, check the output

frequency using your final layout to see if the value of C

should be changed.

PCB Layout Recommendations

For optimum device performance and lowest output phase

noise, the following guidelines should be observed.

1) Each 0.01µF decoupling capacitor should be mounted on

the component side of the board as close to the VDD pin as

possible. No vias should be used between decoupling

capacitor and VDD pin. The PCB trace to VDD pin should

be kept as short as possible, as should the PCB trace to the

ground via. Distance of the ferrite bead and bulk decoupling

from the device is less critical.

2) The external crystal should be mounted next to the device

with short traces. The X1 and X2 traces should not be

routed next to each other with minimum spaces, instead

they should be separated and away from other traces.

3) To minimize EMI and obtain the best signal integrity, the

33Ω series termination resistor should be placed close to

the clock output.

All power supply pins must be connected to the same

voltage, except VDDR and VDDO may be connected to a

lower voltage in order to change the output level. If the

reference output is not used, ground VDDR.

Crystal Load Capacitors

If a crystal is used, the device crystal connections should

include pads for capacitors from X1 to ground and from X2

to ground. These capacitors are used to adjust the stray

4) An optimum layout is one with all components on the

same side of the board, minimizing vias through other signal

layers (the ferrite bead and bulk decoupling capacitor can be

mounted on the back). Other signal traces should be routed

away from the ICS661. This includes signal traces just

underneath the device, or on layers adjacent to the ground

plane layer used by the device.

IDT™ / ICS™ PRECISION AUDIO CLOCK SOURCE

3

ICS661

REV F 051310

Share Link: