IDT82V3380 View Datasheet(PDF) - Integrated Device Technology

Part Name

Description

Manufacturer

IDT82V3380

SYNCHRONOUS ETHERNET WAN PLL

Integrated Device Technology 

IDT82V3380

SYNCHRONOUS ETHERNET WAN PLL

DESCRIPTION

The IDT82V3380 is an integrated, single-chip solution for the Syn-

chronous Equipment Timing Source for Stratum 2, 3E, 3, SMC, 4E and 4

clocks in SONET / SDH equipments, DWDM and Wireless base station,

such as GSM, 3G, DSL concentrator, Router and Access Network appli-

cations.

The device supports three types of input clock sources: recovered

clock from STM-N or OC-n, PDH network synchronization timing and

external synchronization reference timing.

Based on ITU-T G.783 and Telcordia GR-253-CORE, the device con-

sists of T0 and T4 paths. The T0 path is a high quality and highly config-

urable path to provide system clock for node timing synchronization

within a SONET / SDH network. The T4 path is simpler and less config-

urable for equipment synchronization. The T4 path locks independently

from the T0 path or locks to the T0 path.

An input clock is automatically or manually selected for T0 and T4

each for DPLL locking. Both the T0 and T4 paths support three primary

operating modes: Free-Run, Locked and Holdover. In Free-Run mode,

the DPLL refers to the master clock. In Locked mode, the DPLL locks to

the selected input clock. In Holdover mode, the DPLL resorts to the fre-

quency data acquired in Locked mode. Whatever the operating mode is,

the DPLL gives a stable performance without being affected by operat-

ing conditions or silicon process variations.

If the DPLL outputs are processed by T0/T4 APLL, the outputs of the

device will be in a better jitter/wander performance.

The device provides programmable DPLL bandwidths: 0.5 mHz to

560 Hz in 19 steps and damping factors: 1.2 to 20 in 5 steps. Different

settings cover all SONET / SDH clock synchronization requirements.

A high stable input is required for the master clock in different appli-

cations. The master clock is used as a reference clock for all the internal

circuits in the device. It can be calibrated within ±741 ppm.

All the read/write registers are accessed through a microprocessor

interface. The device supports five microprocessor interface modes:

EPROM, Multiplexed, Intel, Motorola and Serial.

In general, the device can be used in Master/Slave application. In

this application, two devices should be used together to enable system

protection against single chip failure. See Chapter 4 Typical Application

for details.

Description

10

May 19, 2009

Share Link: