LF1005-S View Datasheet(PDF) - LEM Industrial
Part Name
Description
Manufacturer
LF1005-S Datasheet PDF : 3 Pages
| |||
Current Transducer LF 1005-S
Isolation characteristics
Vd
R.m.s. voltage for AC isolation test, 50 Hz, 1 mn
3.8
kV
Vw Impulse withstand voltage 1.2/50 µs
16
kV
Min
dCp Creepage distance
20.6
mm
dCl Clearance distance
19.6
mm
CTI Comparative Tracking Index (Group IIIa)
175
Application examples
According to EN 50178 and CEI 61010-1 standards and following conditions :
• Over voltage category OV 3
• Pollution degree PD2
• Non-uniform field
dCp, dCI, VW
Single isolation
Reinforced isolation
EN 50178
Rated isolation voltage
1500 V
1000 V
CEI 61010-1
Nominal voltage
2000 V
1000 V
Safety
This transducer must be used in electric/electronic equipment with respect to
applicable standards and safety requirements in accordance with the manufacturer's
operating instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can carry hazardous
voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious damage.
This transducer is a built-in device, whose conducting parts must be inaccessible
after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
060821/7
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
page 2/3
w w w .lem.com
Share Link: 