LH28F800BJHE-PTTL90 View Datasheet(PDF) - Sharp Electronics
Part Name
Description
Manufacturer
LH28F800BJHE-PTTL90 Datasheet PDF : 47 Pages
| |||
LHF80J03
29
6 ELECTRICAL SPECIFICATIONS
6.1 Absolute Maximum Ratings*
Operating Temperature
During Read, Block Erase,
Full Chip Erase, Word/Byte Write
and Lock-Bit Configuration .............-40°C to +85°C(1)
Storage Temperature
During under Bias ............................... -40°C to +85°C
During non Bias ................................ -65°C to +125°C
Voltage On Any Pin
(except VCC and VCCW) ........... -0.5V to VCC+0.5V(2)
VCC Supply Voltage................................ -0.2V to +4.6V(2)
VCCW Supply Voltage......................... -0.2V to +13.0V(2,3)
Output Short Circuit Current................................100mA(4)
*WARNING: Stressing the device beyond the "Absolute
Maximum Ratings" may cause permanent damage. These
are stress ratings only. Operation beyond the "Operating
Conditions" is not recommended and extended exposure
beyond the "Operating Conditions" may affect device
reliability.
NOTES:
1. Operating temperature is for extended temperature
product defined by this specification.
2. All specified voltages are with respect to GND.
Minimum DC voltage is -0.5V on input/output pins
and -0.2V on VCC and VCCW pins. During transitions,
this level may undershoot to -2.0V for periods <20ns.
Maximum DC voltage on input/output pins are
VCC+0.5V which, during transitions, may overshoot to
VCC+2.0V for periods <20ns.
3. Maximum DC voltage on VCCW may overshoot to
+13.0V for periods <20ns. Applying 12V±0.3V to
VCCW during erase/write can only be done for a
maximum of 1000 cycles on each block. VCCW may be
connected to 12V±0.3V for a total of 80 hours
maximum.
4. Output shorted for no more than one second. No more
than one output shorted at a time.
6.2 Operating Conditions
Symbol
TA
VCC
Temperature and VCC Operating Conditions
Parameter
Min.
Max.
Unit
Operating Temperature
-40
+85
°C
VCC Supply Voltage (2.7V-3.6V)
2.7
3.6
V
Test Condition
Ambient Temperature
6.2.1 Capacitance(1)
Symbol
Parameter
CIN
Input Capacitance
COUT
Output Capacitance
NOTE:
1. Sampled, not 100% tested.
TA=+25°C, f=1MHz
Typ.
Max.
7
10
9
12
Unit
Condition
pF
VIN=0.0V
pF
VOUT=0.0V
Rev. 1.27
Share Link: 