LPC1102UK(2011) View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

Manufacturer

LPC1102UK
(Rev.:2011)

32-bit ARM Cortex-M0 microcontroller; 32 kB flash and 8 kB SRAM

NXP Semiconductors. 

NXP Semiconductors

LPC1102

32-bit ARM Cortex-M0 microcontroller

• Optional windowed operation requires reload to occur between a minimum and

maximum time period, both programmable.

• Optional warning interrupt can be generated at a programmable time prior to

watchdog time-out.

• Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be

disabled.

• Incorrect feed sequence causes reset or interrupt if enabled.

• Flag to indicate watchdog reset.

• Programmable 24-bit timer with internal prescaler.

• Selectable time period from (Tcy(WDCLK)  256  4) to (Tcy(WDCLK)  224  4) in

multiples of Tcy(WDCLK)  4.

• The Watchdog Clock (WDCLK) source can be selected from the IRC or the dedicated

watchdog oscillator (WDO). This gives a wide range of potential timing choices of

watchdog operation under different power conditions.

7.14 Clocking and power control

7.14.1 Crystal oscillators

The LPC1102 includes two independent oscillators. These are the Internal RC oscillator

(IRC) and the Watchdog oscillator. Each oscillator can be used for more than one purpose

as required in a particular application.

Following reset, the LPC1102 will operate from the Internal RC oscillator until switched by

software. This allows systems to operate without any external crystal and the bootloader

code to operate at a known frequency.

See Figure 4 for an overview of the LPC1102 clock generation.

LPC1102

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 4 — 24 June 2011

© NXP B.V. 2011. All rights reserved.

11 of 39

Share Link: