LPC2194 View Datasheet(PDF) - Philips Electronics

Part Name

Description

Manufacturer

LPC2194

Single-chip 16/32-bit microcontrollers; 256 kB ISP/IAP Flash with 10-bit ADC and CAN

Philips Electronics 

Philips Semiconductors

LPC2194

Single-chip 16/32-bit microcontrollers

• Provides Seconds, Minutes, Hours, Day of Month, Month, Year, Day of Week, and

Day of Year.

• Programmable Reference Clock Divider allows adjustment of the RTC to match

various crystal frequencies.

9397 750 12757

Preliminary data

6.19 Pulse width modulator

The PWM is based on the standard Timer block and inherits all of its features,

although only the PWM function is pinned out on the LPC2194. The Timer is

designed to count cycles of the peripheral clock (PCLK) and optionally generate

interrupts or perform other actions when specified timer values occur, based on

seven match registers. The PWM function is also based on match register events.

The ability to separately control rising and falling edge locations allows the PWM to

be used for more applications. For instance, multi-phase motor control typically

requires three non-overlapping PWM outputs with individual control of all three pulse

widths and positions.

Two match registers can be used to provide a single edge controlled PWM output.

One match register (MR0) controls the PWM cycle rate, by resetting the count upon

match. The other match register controls the PWM edge position. Additional single

edge controlled PWM outputs require only one match register each, since the

repetition rate is the same for all PWM outputs. Multiple single edge controlled PWM

outputs will all have a rising edge at the beginning of each PWM cycle, when an MR0

match occurs.

Three match registers can be used to provide a PWM output with both edges

controlled. Again, the MR0 match register controls the PWM cycle rate. The other

match registers control the two PWM edge positions. Additional double edge

controlled PWM outputs require only two match registers each, since the repetition

rate is the same for all PWM outputs.

With double edge controlled PWM outputs, specific match registers control the rising

and falling edge of the output. This allows both positive going PWM pulses (when the

rising edge occurs prior to the falling edge), and negative going PWM pulses (when

the falling edge occurs prior to the rising edge).

6.19.1 Features

• Seven match registers allow up to six single edge controlled or three double edge

controlled PWM outputs, or a mix of both types.

• The match registers also allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Supports single edge controlled and/or double edge controlled PWM outputs.

Single edge controlled PWM outputs all go HIGH at the beginning of each cycle

unless the output is a constant LOW. Double edge controlled PWM outputs can

have either edge occur at any position within a cycle. This allows for both positive

going and negative going pulses.

Rev. 01 — 06 February 2004

© Koninklijke Philips Electronics N.V. 2004. All rights reserved.

20 of 33

Share Link: