LPC2109 View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

Manufacturer

LPC2109

Single-chip 16/32-bit microcontrollers; 64/128/256 kB ISP/IAP flash with 10-bit ADC and CAN

NXP Semiconductors. 

NXP Semiconductors

LPC2109/2119/2129

Single-chip 16/32-bit microcontrollers

I 64/128/256 kB on-chip flash program memory. 128-bit wide interface/accelerator

enables high speed 60 MHz operation.

I In-System Programming (ISP) and In-Application Programming (IAP) via on-chip

bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or

full chip erase takes 400 ms.

I EmbeddedICE-RT interface enables breakpoints and watch points. Interrupt service

routines can continue to execute while the foreground task is debugged with the

on-chip RealMonitor software.

I Embedded Trace Macrocell (ETM) enables non-intrusive high speed real-time tracing

of instruction execution.

I Two interconnected CAN interfaces (one for LPC2109) with advanced acceptance

filters.

I Four-channel 10-bit A/D converter with conversion time as low as 2.44 µs.

I Multiple serial interfaces including two UARTs (16C550), Fast I2C-bus (400 kbit/s) and

two SPIs.

I 60 MHz maximum CPU clock available from programmable on-chip Phase-Locked

Loop with settling time of 100 µs.

I Vectored Interrupt Controller with configurable priorities and vector addresses.

I Two 32-bit timers (with four capture and four compare channels), PWM unit (six

outputs), Real-Time Clock (RTC) and watchdog.

I Up to forty-six 5 V tolerant general purpose I/O pins. Up to nine edge or level sensitive

external interrupt pins available.

I On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz.

I Two low power modes, Idle and Power-down.

I Processor wake-up from Power-down mode via external interrupt.

I Individual enable/disable of peripheral functions for power optimization.

I Dual power supply:

N CPU operating voltage range of 1.65 V to 1.95 V (1.8 V ± 0.15 V).

N I/O power supply range of 3.0 V to 3.6 V (3.3 V ± 10 %) with 5 V tolerant I/O pads.

3. Ordering information

Table 1. Ordering information

Type number

Package

Name

Description

LPC2109FBD64/00 LQFP64

plastic low profile quad flat package; 64 leads;

body 10 × 10 × 1.4 mm

LPC2109FBD64/01 LQFP64

plastic low profile quad flat package; 64 leads;

body 10 × 10 × 1.4 mm

LPC2119FBD64

LQFP64

plastic low profile quad flat package; 64 leads;

body 10 × 10 × 1.4 mm

LPC2119FBD64/00 LQFP64

plastic low profile quad flat package; 64 leads;

body 10 × 10 × 1.4 mm

LPC2119FBD64/01 LQFP64

plastic low profile quad flat package; 64 leads;

body 10 × 10 × 1.4 mm

Version

SOT314-2

SOT314-2

SOT314-2

SOT314-2

SOT314-2

LPC2109_2119_2129_6

Product data sheet

Rev. 06 — 10 December 2007

© NXP B.V. 2007. All rights reserved.

2 of 44

Share Link: