LPC1778FET180(2011) View Datasheet(PDF) - NXP Semiconductors.
Part Name
Description
Manufacturer
LPC1778FET180
(Rev.:2011)
(Rev.:2011)
NXP Semiconductors.
LPC1778FET180 Datasheet PDF : 117 Pages
| |||
NXP Semiconductors
LPC178x/7x
32-bit ARM Cortex-M3 microcontroller
Table 3. Pin description …continued
Not all functions are available on all parts. See Table 2 (Ethernet, USB, LCD, QEI, SD/MMC, DAC pins) and Table 7 (EMC
pins).
Symbol
Description
P1[27]
P1[28]
P1[29]
P1[30]
88 T12 M9 61 [3] I; I/O
PU I
I
I
O
-
O
O
90 T13 P10 63 [3] I; I/O
PU I/O
I
O
O
I/O
O
O
92 U14 N10 64 [3] I; I/O
PU I/O
I
O
O
O
O
O
42 P2 K3 30 [5] I; I/O
PU I
I
I
I/O
O
P1[27] — General purpose digital input/output pin.
USB_INT1 — USB port 1 OTG transceiver interrupt (OTG
transceiver).
USB_OVRCR1 — USB port 1 Over-Current status.
T0_CAP1 — Capture input for Timer 0, channel 1.
CLKOUT — Selectable clock output.
R — Function reserved.
LCD_VD[13] — LCD data.
LCD_VD[21] — LCD data.
P1[28] — General purpose digital input/output pin.
USB_SCL1 — USB port 1 I2C serial clock (OTG transceiver).
PWM1_CAP0 — Capture input for PWM1, channel 0.
T0_MAT0 — Match output for Timer 0, channel 0.
MC_2A — Motor control PWM channel 2, output A.
SSP0_SSEL — Slave Select for SSP0.
LCD_VD[14] — LCD data.
LCD_VD[22] — LCD data.
P1[29] — General purpose digital input/output pin.
USB_SDA1 — USB port 1 I2C serial data (OTG transceiver).
PWM1_CAP1 — Capture input for PWM1, channel 1.
T0_MAT1 — Match output for Timer 0, channel 0.
MC_2B — Motor control PWM channel 2, output B.
U4_TXD — Transmitter output for USART4 (input/output in
smart card mode).
LCD_VD[15] — LCD data.
LCD_VD[23] — LCD data.
P1[30] — General purpose digital input/output pin.
USB_PWRD2 — Power Status for USB port 2.
USB_VBUS — Monitors the presence of USB bus power.
This signal must be HIGH for USB reset to occur.
ADC0_IN[4] — A/D converter 0, input 4. When configured as an
ADC input, the digital function of the pin must be disabled.
I2C0_SDA — I2C0 data input/output (this pin does not use a
specialized I2C pad.
U3_OE — RS-485/EIA-485 output enable signal for UART3.
LPC178X_7X
Objective data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 27 May 2011
© NXP B.V. 2011. All rights reserved.
21 of 117
Share Link: