MIC2551A(2004) View Datasheet(PDF) - Micrel
Part Name
Description
Manufacturer
MIC2551A Datasheet PDF : 11 Pages
| |||
MIC2551A
Configuration Mode
Normal
Disconnect
(D+/D– sharing)
Disconnect
Disable Mode
Prohibited
Micrel
VBUS/VTRM
VIF
Notes
Connected
Connected
Normal supply configuration and operation.
Open
Ground
Connected
Connected
Connected
Open
VP/VM are HIGH outputs, RCV is LOW.
With OE# = 0 and SUS = 1, data lines may be driven with
external devices up to 3.6V.
With D+, D– floating, IIF draws less than 1µA.
VP/VM are HIGH outputs, RCV is LOW.
With D+, D– floating, IIF draws less than 1µA.
Logic controlled inputs pins are Hi-Z.
Connected
Ground
Prohibited condition.
Table 3. Power Supply Configuration
PCB Layout Recommendations
Although the USB standard and applications are not based in
an impedance controlled environment, a properly designed
PCB layout is recommended for optimal transceiver perfor-
mance. The suggested PCB layout hints are as follows:
• Match signal line traces (VP/VM, D+, D–) to
40ps, approximately 1/3 inch if possible. FR-4
PCB material propagation is about 150ps/inch,
so to minimize skew try to keep VP/VM, D+/D–
traces as short as possible.
• For every signal line trace width (w), separate
the signal lines by 1.5 – 2 widths. Place all other
traces at >2 widths from all signal line traces.
• Maintain the same number of vias on each
differential trace, keeping traces approximately
at same separation distance along the line.
• Control signal line impedances to ±10%.
• Keep RS as close to the IC as possible, with
equal distance between RS and the IC for both
D+ and D–.
May 2004
9
M9999-051004
Share Link: 