ADV7176A View Datasheet(PDF) - Analog Devices
Part Name
Description
Manufacturer
ADV7176A Datasheet PDF : 50 Pages
| |||
ADV7175A/ADV7176A
3.3 V SPECIFICATIONS (VAA = 3.0 V–3.6 V1, VREF = 1.235 V, RSET = 300 ⍀. All specifications TMIN to TMAX2 unless otherwise noted)
Parameter
Conditions1
Min
Typ
Max
Unit
STATIC PERFORMANCE3
Resolution (Each DAC)
Accuracy (Each DAC)
Integral Nonlinearity
Differential Nonlinearity
Guaranteed Monotonic
10
Bits
±1
LSB
±1
LSB
DIGITAL INPUTS
Input High Voltage, VINH
Input Low Voltage, VINL
Input Current, IIN3, 4
Input Current, IIN3, 5
Input Capacitance, CIN
DIGITAL OUTPUTS
Output High Voltage, VOH
Output Low Voltage, VOL
Three-State Leakage Current3
Three-State Output Capacitance3
VIN = 0.4 V or 2.4 V
VIN = 0.4 V or 2.4 V
ISOURCE = 400 µA
ISINK = 3.2 mA
2
V
0.8
V
±1
µA
± 50
µA
10
pF
2.4
V
0.4
V
10
µA
10
pF
ANALOG OUTPUTS3
Output Current6, 7
Output Current8
DAC-to-DAC Matching
Output Compliance, VOC
Output Impedance, ROUT
Output Capacitance, COUT
POWER REQUIREMENTS3, 9
VAA
Normal Power Mode
IDAC (max)10
IDAC (min)10
ICCT9
Low Power Mode
IDAC (max)10
IDAC (min)10
ICCT11
Power Supply Rejection Ratio
IOUT = 0 mA
COMP = 0.1 µF
16.5
17.35 18.5
mA
5
mA
2.0
%
0
1.4
V
15
kΩ
30
pF
3.0
3.3
3.6
V
150
155
mA
20
mA
45
mA
75
15
45
0.01 0.5
mA
mA
mA
%/%
NOTES
11The max/min specifications are guaranteed over this range. The max/min values are typical over 3.0 V to 3.6 V.
12Temperature range TMIN to TMAX: 0°C to 70°C.
13 Guaranteed by characterization.
14All digital input pins except pins RESET and RTC/SCRESET.
15Excluding all digital input pins except pins RESET and RTC/SCRESET.
16Full drive into 37.5 Ω load.
17DACs can output 35 mA typically at 3.3 V (RSET = 150 Ω and RL = 75 Ω), optimum performance obtained at 18 mA DAC current (RSET = 300 Ω and RL = 150 Ω.
18Minimum drive current (used with buffered/scaled output load).
19Power measurements are taken with Clock Frequency = 27 MHz. Max T J = 110°C.
10IDAC is the total current (min corresponds to 5 mA output per DAC, max corresponds to 38 mA output per DAC) to drive all four DACs. Turning off individual
DACs reduces IDAC correspondingly.
11ICCT (Circuit Current) is the continuous current required to drive the device.
Specifications subject to change without notice.
REV. C
–3–
Share Link: 