PI5C3306LE(2010) View Datasheet(PDF) - Pericom Semiconductor
Part Name
Description
Manufacturer
PI5C3306LE Datasheet PDF : 4 Pages
| |||
PI5C3306
2-Bit Bus Switch with Active Low Enables
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature.......................................................... –65°C to +150°C
Ambient Temperature with Power Applied......................... –40°C to +85°C
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device.
Supply Voltage to Ground Potential .................................... –0.5V to +4.6V This is a stress rating only and functional operation
DC Input Voltage.................................................................. –0.5V to +5.5V
DC Output Current............................................................................ 120mA
of the device at these or any other conditions above
those indicated in the operational sections of this
specification is not implied. Exposure to absolute
Power Dissipation..................................................................................0.5W maximum rating conditions for extended periods may
affect reliability.
DC Electrical Characteristics (Over Operating Range, TA = –40°C to +85°C, VCC = 5.0V ±10%)
Parameters
Description
Test Conditions(1)
Min. Typ.(2) Max.
VIH
Input HIGH Voltage
Guaranteed logic HIGH level
2.0
VIL
Input LOW Voltage
Guaranteed logic LOW level
–0.5
0.8
IIH
Input HIGH Current
VCC = Max., VIN = VCC
±1
IIL
Input LOW Current
VCC = Max., VIN = GND
±1
IOZ
High Impedance Output Current 0 ≤ A, B ≤ VCC
±1
VH
Input Hysteresis at Control Pins
300
RON
Switch on Resistance (3)
VCC = 4.5V, VIN = 0.0V, ION = 30mA or 64mA
VCC = 4.5V, VIN = 2.4V, ION = 15mA
5
7
10 15
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 5.0V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined
by the lower of the voltages on the two (A,B) pins.
Units
V
µA
mV
Ω
Capacitance (TA = 25°C, f = 1 MHz)
Parameters(1)
Description
CIN
Input Capacitance
COFF
A/B Capacitance, Switch Off
CON
Notes:
A/B Capacitance, Switch On
1. This parameter is determined by device characterization but is not production tested.
Test Conditions
VIN = 0V
Typ.
3
5
10
Units
pF
Power Supply Characteristics
Parameters
Description
Test Conditions(1)
Min.
ICC
∆ICC
Notes:
Quiescent Power Supply Current
Quiescent Current per Input HIGH
VCC = Max.
VIN = GND or VCC
VIN = 3.4V(3)
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device.
2. Typical values are at VCC = 5.0V, +25°C ambient.
3. Per TTL driven input (VIN = 3.4V, control inputs only); A and B pins do not contribute to ICC.
10-0213
2
Typ.(2)
0.1
Max.
3.0
2.5
PS8857B
Units
µA
mA
09/27/10
Share Link: 