UPD78F0058GC-8BT View Datasheet(PDF) - NEC => Renesas Technology

Part Name

Description

Manufacturer

UPD78F0058GC-8BT

8-Bit Single-Chip Microcontrollers

NEC => Renesas Technology 

Major Revisions in This Edition (2/2)

Page

p. 263

pp. 267, 268

pp. 269, 270, 272, 273

p. 280

p. 379

p. 468

p. 477

p. 483

p. 525

p. 535

pp. 538 to 549

pp. 567 to 596

pp. 597 to 626

pp. 627 to 657

pp. 658, 659

pp. 660, 661

pp. 662 to 665

pp. 666, 667

pp. 668 to 684

Description

Modification of Figure 14-5 A/D Converter Basic Operation

Addition of Table 14-2 A/D Conversion Sampling Time and A/D Converter Start Delay Time

Addition of 14.5 How to Read A/D Converter Characteristics Table

14.6 A/D Converter Cautions

Change of description in (1) Power consumption in standby mode

Addition of (3) Conflict operations

Addition of (6) Input impedance of ANI0 to ANI7 pins

Addition of (10) Timing at which A/D conversion result is undefined

Addition of (11) Notes on board design

Addition of (12) AVREF0 pin

Addition of (13) Internal equivalent circuit of ANI0 to ANI7 pins and permissible signal

source impedance

Addition of description of processing when D/A converter is not used in 15.5 D/A Converter

Cautions (3) AVREF1 pin

Addition of 17.4.7 Restrictions in I2C bus mode 2

Addition of 19.4.5 Restrictions in UART mode 2

Addition of Caution when interrupt is acknowledged to Figure 21-2 Interrupt Request Flag

Register Format

Addition of description on TI01/P01/INTP1 pin to Figure 21-5 Format of External Interrupt

Mode Register 0

Addition of Caution to 25.1 ROM Correction Function

Modification of Table 26-1 Differences Between µPD78F0058, 78F0058Y and Mask ROM

Versions

Total revision of description on flash memory programming as 26.3 Flash Memory

Characteristics

Addition of CHAPTER 28 ELECTRICAL SPECIFICATIONS (MASK ROM VERSION)

Addition of CHAPTER 29 ELECTRICAL SPECIFICATIONS (FLASH MEMORY VERSION)

Addition of CHAPTER 30 ELECTRICAL SPECIFICATIONS (FLASH MEMORY VERSION (VDD

= 2.2 V))

Addition of CHAPTER 31 CHARACTERISTICS CURVES (REFERENCE VALUES)

Addition of CHAPTER 32 PACKAGE DRAWINGS

Addition of CHAPTER 33 RECOMMENDED SOLDERING CONDITIONS

Correction of APPENDIX A DIFFERENCES BETWEEN µPD78054, 78058F, AND 780058

SUBSERIES

Total revision of APPENDIX B DEVELOPMENT TOOLS

Transfer of description of embedded software to APPENDIX B DEVELOPMENT TOOLS

The mark shows major revised points.

User's Manual U12013EJ3V2UD

7

Share Link: