AD673 View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

AD673

8-Bit A/D Converter

Analog Devices 

AD673

BIPOLAR CONNECTION

To obtain the bipolar –5 V to +5 V range with an offset binary

output code, the bipolar offset control pin is left open.

A –5.00 volt signal will give a 8-bit code of 00000000; an input

of 0.00 volts results in an output code of 10000000 and +4.961

volts at the input yields the 11111111 code. The nominal trans-

fer curve is shown in Figure 6.

Figure 6. AD673 Transfer Curve—Bipolar Operation

Note that in the bipolar mode, the code transitions are offset

1/4 LSB such that an input voltage of 0 volts –5 mV to +35 mV

yields the code representing zero (10000000). Each output code

is then centered on its nominal input voltage.

Full-Scale Calibration

Full-Scale Calibration is accomplished in the same manner as in

Unipolar operation except the full-scale input voltage is +4.61

volts.

Negative Full-Scale Calibration

The circuit in Figure 4a can also be used in Bipolar operation to

offset the input voltage (nominally –5 V) which results in the

000000 00 code. R2 should be omitted to obtain a symmetrical

range.

The bipolar offset control input is not directly TTL compatible

but a TTL interface for logic control can be constructed as

shown in Figure 7.

SAMPLE-HOLD AMPLIFIER CONNECTION

TO THE AD673

Many situations in high-speed acquisition systems or digitizing

rapidly changing signals require a sample-hold amplifier (SHA)

in front of the A-D converter. The SHA can acquire and hold a

signal faster than the converter can perform a conversion. A

SHA can also be used to accurately define the exact point in

time at which the signal is sampled. For the AD673, a SHA can

also serve as a high input impedance buffer.

Figure 8 shows the AD673 connected to the AD582 monolithic

SHA for high speed signal acquisition. In this configuration, the

AD582 will acquire a 10 volt signal in less than 10 µs with a

droop rate less than 100 µV/ms.

DR goes high after the conversion is initiated to indicate that re-

set of the SAR is complete. In Figure 8 it is also used to put the

AD582 into the hold mode while the AD673 begins its conver-

sion cycle. (The AD582 settles to final value well in advance of

the first comparator decision inside the AD673).

DR goes low when the conversion is complete placing the

AD582 back in the sample mode. Configured as shown in Fig-

ure 8, the next conversion can be initiated after a 10 µs delay to

allow for signal acquisition by the AD582.

Observe carefully the ground, supply, and bypass capacitor con-

nections between the two devices. This will minimize ground

noise and interference during the conversion cycle.

Figure 8. Sample-Hold Interface to the AD673

Figure 7. Bipolar Offset Controlled by Logic Gate

Gate Output = 1 Unipolar 0 V–10 V Input Range

Gate Output = 0 Bipolar ±5 V Input Range

REV. A

–5–

Share Link: