PIC16F/LF182X/PIC12F/LF1822
4.3.7 RESET ADDRESS
The Reset Address command will reset the address to
0000h, regardless of the current value. The address is
used in program memory or the configuration memory.
FIGURE 4-7:
RESET ADDRESS
ICSPCLK
ICSPDAT
123
456
TDLY
0
1
1
0
1
X
N
Address
4.3.8
BEGIN INTERNALLY TIMED
PROGRAMMING
A Load Configuration or Load Data for Program
Memory command must be given before every Begin
Programming command. Programming of the
addressed memory will begin after this command is
received. An internal timing mechanism executes the
write. The user must allow for the program cycle time,
TPINT, for the programming to complete.
The End Externally Timed Programming command is
not needed when the Begin Internally Timed
Programming is used to start the programming.
The program memory address that is being
programmed is not erased prior to being programmed.
However, the EEPROM memory address that is being
programmed is erased prior to being programmed with
internally timed programming.
FIGURE 4-8:
BEGIN INTERNALLY TIMED PROGRAMMING
ICSPCLK
ICSPDAT
123
456
TPINT
0
00
1
0X
Next Command
1
2
3
X
X
X
0000h
Next Command
1
2
3
X
X
X
2010 Microchip Technology Inc.
Advance Information
DS41390C-page 17