RF2488 View Datasheet(PDF) - RF Micro Devices

Part Name

Description

Manufacturer

RF2488

MULTI-MODE DUAL-BAND LNA MIXER

RF Micro Devices 

Preliminary

Application Information

Calculating the mixer output match

The evaluation boards mixer output match is explained below.

IF+

L1

IF-

VCC

L2 R1

C3

IF OUT

C1

C2

RF2488

The match is made up of six components, each of which is discussed below.

Inductor L1

This inductor, along with capacitors C1 and C2 determine the resonant frequency of the current combining circuit, as well

as the output impedance at the resonant point. The output impedance will be dependent on the parasitic resistance of

the inductor RP. A high Q inductor will result in a high output impedance.

8

Inductor L2

This inductor functions as a choke at the IF frequency, and should be made as large as possible, to not interact with the

current combiner network. In addition, it provides a DC path from VCC to the mixer core transistors.

Capacitors C1 and C2

These capacitors should be equal, and along with L1, define the resonant frequency.

Capacitor C3

This capacitor is used to provide a DC-block.

Resistor R1

This is primarily used to set the output impedance of the network. The impedance at the resonant frequency can be

measured, and R1 can be placed in parallel to reduce the real impedance to the desired value. Alternatively, an approxi-

mation can be made using the following equation.

R1

=

æ

è

------1-------

ROUT

–

R--1--P--øö

–1

This is only an approximation, because it assumes the capacitors have infinite Q, and does not take into account PCB

parasitics.

The following equation can be used to approximately calculate the resonant frequency of the circuit.

fIF

=

-----------------------1------------------------

2π

L----1--

2

(

C

1

+

CE

Q

)

Rev A0 010905

8-131

Share Link: