SI2401 View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
Manufacturer
SI2401 Datasheet PDF : 72 Pages
| |||
Si2401/Si3008
Table 4. AC Characteristics
(VD = 3.0 to 3.6 V, TA = 0 to 70 °C for K-Grade, Fs = 8 kHz)
Parameter
Symbol
Test Condition
Min Typ Max Unit
Sample Rate
Fs
—
8
—
kHz
Clock Input Frequency
Clock Input Frequency
FXTL
FXTL
default
<10 kΩ resistor between pin 11
and GND
— 4.9152 —
— 27 —
MHz
MHz
Receive Frequency Response
Low –3 dBFS Corner
—
5
—
Hz
Transmit Full Scale Level1
VFS
Receive Full Scale Level1,2
VFS
Dynamic Range3,4,5
DR
Dynamic Range3,4,5
DR
–1 dBm
–1 dBm
IL = 100 mA
IL = 20 mA
— 0.98 — VPEAK
— 0.98 — VPEAK
— 80 —
dB
— 80 —
dB
Transmit Total Harmonic
Distortion5,6
THD
IL = 20 mA
— 75 —
dB
Dynamic Range (Caller ID Mode)7 DRCID
VIN = 1 kHz, –13 dBm
— 50 —
dB
Notes:
1. Measured at TIP and RING with 600 Ω. termination at 1 kHz, as shown in Figure 1.
2. Receive full-scale level produces –0.9 dBFS.
3. DR = 20 x log (rms VFS/rms VIN)+ 20 x log (rms VIN/rms noise, excluding harmonics). VFS is the –1 dBm full-scale
level.
4. Measurement is 300 to 3400 Hz. Applies to both transmit and receive paths.
5. VIN = 1 kHz, –3 dBFS
6. THD = 20 x log (rms distortion / rms signal).
7. DRCID = 20 x log (rms VCID/rms VIN)+ 20 x log (rms VIN/rms noise). VCID is the 6 V full-scale level.
6
Rev. 1.1
Share Link: 