T89C51RD2-3CFI-M View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

T89C51RD2-3CFI-M

0 to 40 MHz Flash Programmable 8-bit Microcontroller

Atmel Corporation 

T89C51RD2

XTAL1

FXTAL

FOSC

:12

0

1

T2

C/T2

TR2

T2CONreg T2CONreg

(DOWN COUNTING RELOAD VALUE)

FFh

(8-bit)

FFh

(8-bit)

TL2

(8-bit)

TH2

(8-bit)

T2EX:

if DCEN=1, 1=UP

if DCEN=1, 0=DOWN

if DCEN = 0, up counting

TOGGLE T2CONreg

EXF2

TF2

T2CONreg

TIMER 2

INTERRUPT

RCAP2L RCAP2H

(8-bit)

(8-bit)

(UP COUNTING RELOAD VALUE)

Figure 5. Auto-Reload Mode Up/Down Counter (DCEN = 1)

6.4.2. Programmable Clock-Output

In the clock-out mode, timer 2 operates as a 50%-duty-cycle, programmable clock generator (See Figure 6) . The

input clock increments TL2 at frequency FOSC/2. The timer repeatedly counts to overflow from a loaded value.

At overflow, the contents of RCAP2H and RCAP2L registers are loaded into TH2 and TL2. In this mode, timer

2 overflows do not generate interrupts. The formula gives the clock-out frequency as a function of the system

oscillator frequency and the value in the RCAP2H and RCAP2L registers :

Clock – OutFrequency = 4-----×-----(--6---5---5---3---6-----–----R----C-F----oA---s-P--c--2---H------⁄---R----C----A----P-----2---L----)

For a 16 MHz system clock, timer 2 has a programmable frequency range of 61 Hz

(FOSC/216) to 4 MHz (FOSC/4). The generated clock signal is brought out to T2 pin (P1.0).

Timer 2 is programmed for the clock-out mode as follows:

• Set T2OE bit in T2MOD register.

• Clear C/T2 bit in T2CON register.

• Determine the 16-bit reload value from the formula and enter it in RCAP2H/RCAP2L registers.

• Enter a 16-bit initial value in timer registers TH2/TL2. It can be the same as the reload value or a different

one depending on the application.

• To start the timer, set TR2 run control bit in T2CON register.

18

Rev. F - 15 February, 2001

Share Link: