STK621-017 View Datasheet(PDF) - SANYO -> Panasonic

Part Name

Description

Manufacturer

STK621-017

TENTATIVE

SANYO -> Panasonic 

STK621-017

ＴＥＮＴＡＴＩＶＥ

01.Nov.2002

Usage Precautions

1. By the addition of the diode for the bootstrap (DB : high speed type, withstand voltage equa

l to or more than 600V) and of the capacitor (CB : about 1 to 47μF), a single power supply

drive is enabled. In this case, it makes a lower side IGBT ON (input signal of lower side

makes LOW). Then it charges in CB. Incidentally, in case of start-up and so on, when the

voltage of CB is low, the big charging electric current flows and sometimes becomes the

cause which exerts the bad influence of the noise and so on. Put limitation resistance RB

(Several Ω to about tens of Ω). (When not using bootstrap circuit, each upper side

pre-drive power supply needs an independent power supply. Externally set.) Also, the upper

side power supply voltage sometimes declines by the way of controlling. Confirm it

2. Because the jump voltage which is accompanied by the vibration in case of switching

operation occurs by the influence of the floating inductance of the wiring of the outer

power supply which is connected with of the + terminal and the – terminal, restrains and

spares serge voltage being as the connection of the snubber circuit (Capacitor / CS / about

0.1 - 10 μF) for the voltage absorption with the neighborhood as possible between + and the

- terminal, and so on, with making a wiring length (among the terminals each from CI) short

and making a wiring inductance small.

3. Iso terminal (20pin) is for the electric current monitor. Be careful, because the

overcurrent protection does not operate when short-circuiting in the Iso terminal and the

Vss terminal.

4. Output form of the FAULT terminal is open DRAIN (it is operating as FAULT when becoming LOW).

When the pull up with the resistance, use above 5.6KΩ.

5. The overcurrent protection feature operates only when it is possible to do a circuit control

normally. For the safety, put a fuse, and so on in the Vcc line.

6. Because the IC sometimes destroys and bursts when motor connection terminal (3pin,6pin,9pin)

becomes open while the motor turns, especially, be careful of the connection ( the soldering

condition ) of this terminal.

This data shows the example of the application circuit, does not guarantee a design as the mass.

ＳＡＮＹＯ Electric Co.,Ltd. Semiconductor Company

No.7/8

Share Link: