STM32F050C4 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F050C4

Low- and medium-density advanced ARM™-based 32-bit MCU with up to 32 Kbytes Flash, timers, ADC and comm. interfaces

STMicroelectronics 

STM32F050xx

Functional overview

3.13

Inter-integrated circuit interface (I2C)

The I2C interface (I2C1) can operate in multimaster or slave mode. It can support Standard

mode (up to 100 kbit/s), Fast mode (up to 400 kbit/s) and Fast Mode Plus (up to 1 Mbit/s)

with 20 mA output drive.

It supports 7-bit and 10-bit addressing modes, multiple 7-bit slave addresses (2 addresses,

1 with configurable mask). It also includes programmable analog and digital noise filters.

Table 6.

Comparison of I2C analog and digital filters

Analog filter

Digital filter

Pulse width of

suppressed spikes

Benefits

≥ 50 ns

Available in Stop mode

Drawbacks

Variations depending on

temperature, voltage, process

Programmable length from 1 to 15

I2C peripheral clocks

1. Extra filtering capability vs.

standard requirements.

2. Stable length

Wakeup from Stop on address

match is not available when digital

filter is enabled.

In addition, I2C1 provides hardware support for SMBUS 2.0 and PMBUS 1.1: ARP

capability, Host notify protocol, hardware CRC (PEC) generation/verification, timeouts

verifications and ALERT protocol management. I2C1 also has a clock domain independent

from the CPU clock, allowing the I2C1 to wake up the MCU from Stop mode on address

match.

The I2C interface can be served by the DMA controller.

3.14

Universal synchronous/asynchronous receiver transmitter

(USART)

The device embeds an universal synchronous/asynchronous receiver transmitters

(USART1), which communicates at speeds of up to 6 Mbit/s.

It provides hardware management of the CTS, RTS and RS485 DE signals, multiprocessor

communication mode, master synchronous communication and single-wire half-duplex

communication mode. It also supports SmartCard communication (ISO 7816), IrDA SIR

ENDEC, LIN Master/Slave capability, auto baud rate feature and has a clock domain

independent from the CPU clock, allowing it to wake up the MCU from Stop mode.

The USART interface can be served by the DMA controller.

Doc ID 023683 Rev 1

21/97

Share Link: