SX1211 View Datasheet(PDF) - Semtech Corporation

Part Name

Description

Manufacturer

SX1211

Ultra-Low Power Integrated UHF Transceiver

Semtech Corporation 

ADVANCED COMMUNICATIONS & SENSING

9. Revision History

Revision 5

Increase maximum Bit Rate in FSK

Update minimum XO frequency

Add the manual reset description

Insert decoupling recommendation for battery

operated systems

Add Tools ordering information

Revision 6

Update SPI speed

Clarify default fc value in Table 29

Clarify MISO state in SPI timing figures

Improve ESD rating description

SX1211

Revision 7

Describe PLL_LOCK pin state in Table 13

Improve note in section 5.4.1

Clarify Table 5 measurement conditions

Clarify /Fifoempty interrupt source behavior

Correct Vtune in Figure 5

Adjust VCO tuning range in section 3.2.5.2

10. Contact Information

Semtech Corporation

Advanced Communication and Sensing Products Division

200 Flynn Road, Camarillo, CA 93012

Phone (805) 498-2111 Fax: (805) 498-3804

© Semtech 2008

All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner.

The information presented in this document does not form part of any quotation or contract, is believed to be accurate and

reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use.

Publication thereof does not convey nor imply any license under patent or other industrial or intellectual property rights.

Semtech. assumes no responsibility or liability whatsoever for any failure or unexpected operation resulting from misuse,

neglect improper installation, repair or improper handling or unusual physical or electrical stress including, but not limited to,

exposure to parameters beyond the specified maximum ratings or operation outside the specified range.

SEMTECH PRODUCTS ARE NOT DESIGNED, INTENDED, AUTHORIZED OR WARRANTED TO BE SUITABLE FOR

USE IN LIFE-SUPPORT APPLICATIONS, DEVICES OR SYSTEMS OR OTHER CRITICAL APPLICATIONS. INCLUSION

OF SEMTECH PRODUCTS IN SUCH APPLICATIONS IS UNDERSTOOD TO BE UNDERTAKEN SOLELY AT THE

CUSTOMER’S OWN RISK. Should a customer purchase or use Semtech products for any such unauthorized application,

the customer shall indemnify and hold Semtech and its officers, employees, subsidiaries, affiliates, and distributors harmless

against all claims, costs damages and attorney fees which could arise.

Rev 7 – Sept 2nd, 2008

Page 92 of 92

www.semtech.com

Share Link: