Philips Semiconductors
Photodiode and amplifier IC for
CD and DVD applications
Preliminary specification
TZA1045
SYMBOL
PARAMETER
CONDITIONS
MIN.
TYP.
MAX. UNIT
sCD-ROM output current sensitivity reading; λ = 785 nm; note 11
for CD-ROM
Io(cen)
−
Io(sat)
−
Io(RFP), Io(RFN)
−
86.4
−
346
−
32.4
−
A/W
A/W
A/W
Notes
1. The supplies are connected internally by diodes. Differences between the supply voltages should not exceed 0.3 V.
2. Estimated average power consumption (typical value):
P = VDD × (1.4 × Io(av) × 9 + IDD1 + IDD2) where Io(av) is the average output current.
Conditions: VDD = VDD1 = VDD2 and Io < 8 mA.
3. Outputs A, B, C, and D: Io = 1 mA output current. Definition of matching: (---I--A----I+--o---(I-m-B---a--+-x--)--I-–C----I-+-o---(-Im--D--i-n-)--)-×-----14---- – Vref × I(o)av where
Vref = Vref1 = Vref2 (see Fig.5) and I(o)av is the average output current.
4. The clipping function is active in the CD-R write mode for the segment outputs (not for outputs RFP and RFN) and
in the read mode for all outputs. In the read mode, the clipping level is increased to 8 mA.
5. Outputs E, F, G, and H: Io = 1.5 mA output current. Definition of matching: (---I--E----I+--o---(I-m-F---a-+--x--)-I--–G----I-+-o---(-Im--H--i-n-)--)-×-----14---- – Vref × I(o)av where
Vref = Vref1 = Vref2 (see Fig.5) and I(o)av is the average output current.
Msens = ±7% for reading CD-RW, CD-ROM, DVD+RW and writing CD-R mode.
6. The settling time includes the recovery time.
7. Definition: 20log × I-I-R-R---FF---PP-----+–----I-I-RR----FF---NN--
8. The sensitivity of the TZA1045 is specified in A/W because it has current outputs. In the application diagram
(see Fig.5) the resistors of 150 Ω convert the currents into voltages (V/W). The maximum absolute spread is ±10%.
9. Writing without clipping.
10. Writing with clipping in CD-R mode for all segment outputs (not outputs RFP and RFN).
11. Reading with clipping active and switched to a level of typical 8 mA.
2003 Jun 26
13