µPD16662
System Configuration Example
An example of configuring a liquid-crystal panel of VGA half-size (480 × 320 dots lengthwise) by using four LSIs
and two row drivers.
• Each column driver sets the LSI No. with PL0, PL1 pins.
• The DIR pins of each column driver are all set to low level.
• Only one of the column drivers is set to the master; all the others are set to the slave. Signals are supplied from the
master column driver to the slave column driver and to the row driver.
• Connect a resistor for the oscillator to the OSC1 and OSC2 pins of the master. Leave the OSC1 and OSC2 pins of
the slave open.
• The signals from the system (D0 through D15, A0 through A16, /CS, /OE, /WE, /UBE, RDY, /RESET, and /DOFF)
are connected to all the column drivers in parallel. Connect a pull-up resistor to the RDY signal.
• The TEST pin is used to test the LSI. Open or connect this pin to GND when the system is configured.
VCC2
PULSE
STB
/FRM
/DOUT, /DOFF '
L1
L2
/REFRH
Master
No.1
OSC1
OSC2
Y1
Y240 Y1
Slave
No.1
Y240
RDY
/DOFF
/RESET
D0 - D15
A0 - A16
Control
(/CS, /OE,
/WE, /UBE)
Row
driver
160 Scanning
direction
Row
driver
Scanning
160 direction
Y240
Y1 Y240
Y1
Slave
No.1
Slave
No.1
Remark The /DOFF' pin is an input pin of µPD16667.
18