Data Sheet
XE1202
The standard power up sequence from sleep to receiver mode uses a “boost” procedure; this “boost” sequence is
selected by setting the RTParam_WBB parameter to “0”. The sequence is described in Figure 7 below
Mode = 000 Mode = 001
- Sleep
- Ref Xtal
oscillator
running
Mode = 010
- Baseband
- Ref Xtal
oscillator
running
≥TS_OS
≥TS_BBR
RTParam_WBB =0
Mode = 011
- Frequency
synthesizer
- Baseband
- Ref Xtal oscillator
running
≥TS_FS
Received data valid
Mode = 100
Mode=001
- RF Front End
- Frequency synthesizer
- Baseband
- Ref Xtal oscillator
running
- Ref Xtal
oscillator
running
≥TS_BB2
t
Figure 7 Standard “boosted” power up sequence from Stand By to Receiver Mode
The typical current consumption values during the standard power-up sequence from Stand-by to Receiver Mode is
the following
<1 uA
Mode= 000
0.85 mA
Mode= 001
3.0 mA
Mode=010
RTParam_WBB =0
11.5 mA
14.0 mA
Mode =011
Mode = 100
≥TS_OS
≥TS_BBR
≥TS_FS
≥TS_BB2
t
Figure 8 Typical current consumption profile during a standard “boosted” power up sequence from Stand By to Receiver Mode
The standard power up sequence from sleep to transmit mode is described in Figure 9 below
Mode = 000 Mode = 001 Mode = 110 Mode =111
Transmission
- Sleep
- Ref Xtal
oscillator
running
≥TS_OS
- Frequency
synthesizer
- Ref Xtal
oscillator
running
- Power Amplifier
- Frequency synthesizer
- Ref Xtal oscillator
running
≥TS_FS
≥TS_TR
Figure 9 Standard power up sequence from Stand by to Transmit Mode
Mode=001
- Ref Xtal
oscillator
running
t
20
D0211-105