ZXCT1021
Application Information
The devices have fixed dc voltage gains of 10, no external scaling resistors are required for the output. Output
voltage is simply defined as:
Vout = 10 x Vsense (V)
Where Vsense = Vin - VLoad
PCB trace shunt resistor for low cost solution
The figure below shows a PCB layout suggestion for a low cost solution where a PCB resistive trace in
replacement for a conventional shunt resistor, can be used. The resistor section is 25mm x 0.25mm giving
approximately 150mΩ using 1 oz copper. Smaller resistances can be used if required.
GND
Load
Total circuit solution: 1 component. Shows area of 150mΩ sense resistor
compared to SOT23 package.
Practical tolerance of the PCB resistor will be around 5% depending on
manufacturing methods.
PINOUT
N/C 1
GND 2
Vout 3
5 Load
4 Vin
Top view
PIN NAME PIN FUNCTION
N/C
Not internally connected
GND
Ground
Vout
Voltage output referenced to GND. Intended to
drive high impedance loads
Load
High impedance negative sense voltage input
Vin
Supply and positive sense voltage input
ISSUE 2 - MARCH 2004
5
SEMICONDUCTORS