ACE100 View Datasheet(PDF) - Thaler Corporation

Part Name

Description

Manufacturer

ACE100

Evaluation Kit For ADC100 Series A/D Converters

Thaler Corporation 

GETTING STARTED

The ACE100 Evaluation Kit includes the following

items:

1) Evaluation Board

2) DB-9 Serial Cable

3) 4 Pin DIN Analog Input Cable

4) 3 1/2" Floppy Disk With BASIC Program

5) ADC Data Sheet

6) ACE100 Data Sheet

ADC150 Application Note:

The ACE100PT software enables the user to

easily check out the different modes that the

ADC150 can be operated in.

When an autozero is performed, the ADC150

microprocessor is reset. After startup, the

ADC150 is configured with the default mode

settings (ie. 22 Bits, 60 Hz., etc.) If a different

mode is required, it must be set after the

autozero has been performed.

ACE100 SETUP:

1) Connect the DB9 serial cable to the computer

and the ACE100 board.

2) Connect the 4 Pin DIN Analog input cable to

ACE100 board.

3) Connect the power supply inputs to the

ACE100 board.

4) Turn on the power supply and let the ACE100

warmup for 5 minutes.

5) There are 2 files on the floppy disk,

ACE100PT.BAS and QBASIC. If the computer

has a hard disk, the files can be copied and

executed from the hard disk.

6) To start the software, type QB ACE100PT to

load the BASIC software.

7) Hit the F5 key to start the program. The

ACE100 main menu will appear.

8) Enter the selection for the converter type then

follow the subsequent menus.

9) The scale factor for the ADC’s is set in the

Basic program. The adjustment can be found

in the SCALEADJ subroutine for the

ADC100/150 converters. The ADC180

converter is in the SCALEADJ180 subroutine.

ACE100 DS JUN. 99 REV. D

Share Link: