PAM8603MDET View Datasheet(PDF) - Power Analog Micoelectronics

Part Name

Description

Manufacturer

PAM8603MDET

3W Filterless Stereo Class-D Audio Amplifier with DC Volume Control

Power Analog Micoelectronics 

PAM8603M

3W Filterless Stereo Class-D Audio Amplifier with DC Volume Control

Application Notice

1. When the PAM8603M works with LC filters, it

should be connected with the speaker before it is

powered on, otherwise it will be damaged easily.

2. When the PAM8603M works without LC

filters, it's better to add a ferrite chip bead at the

outgoing line of speaker to suppress the possible

electromagnetic interference.

3. The input signal should not be too high. If too

high, it will cause the clipping of output signal

when increasing the volume. Because the DC

volume control of the PAM8603M has big gain, it

will make the device damaged.

4. When testing the PAM8603M without LC

filters by using resistor instead of speaker as the

output load, the test results, e.g. efficiency, will

be worse than those using speaker as load.

Test Setup for Performance Testing

AP System

Generator

PAM8603M Demo Board

Input

+OUT

Load

GND

-OUT

VDD

AP

LPF

AUX-0025

AP System

Analyzer

Power Supply

Notes

1. The AP AUX-0025 low pass filter is necessary for class-D amplifier measurement done by AP analyzer.

2. Two 22μH inductors are used in series with load resistor to emulate the small speaker for efficiency

measurement.

Power Analog Microelectronics,Inc

www.poweranalog.com

9

10/2008 Rev 1.0

Share Link: